The speed of computerized embroidery machine is set according to the configuration of the machine, which has been set at the time of design.
It is irresponsible for the machine to only increase the control speed, which will increase the wear and tear of the machine and reduce its performance. At present, the most prominent quality problem of domestic embroidery machine appears in the mechanical part. The mechanical part focuses on the quality control of parts and the precision control of assembly.
As for the quality of accessories, most of the accessories of embroidery machine enterprises are outsourced, so the key to control this part of quality is to control the quality of outsourced accessories. The fact that products with high profit returns and low profits face cruel competition.
Driven by economic interests, there are many fake parts in China, which requires enterprises to focus on long-term economic benefits and brand benefits, strictly implement the reward and punishment system for purchasing parts, improve the quality of purchasing personnel, and ensure the quality of parts from the source to the factory.
In terms of assembly accuracy, enterprises should strive to train skilled assembly personnel. At the same time, improve the quality inspection facilities and equip special instruments in the assembly process to improve the assembly accuracy.
Extended data:
Precautions:
1. When all the pins are in the high position, do not turn the dial by hand.
2. When the pin is in a high position, it can't jog, otherwise it is easy to get stuck.
3. Make preparations before driving the tie rod, thread the bottom thread, select the pattern to be embroidered, select the working mode matching with the pattern (such as coiling, sawtooth, winding and Ping Xiu) and appropriate embroidery parameters.
4. Before driving the pull rod, check whether all pins are put down (check whether the manipulator is in the working position when embroidering sawtooth embroidery). If not, manually put all the pins down (install the manipulator in the working position), and then pull the lever to drive, otherwise it will easily cause machine damage or flower leakage.
5. When embroidering the gold sheet, the switch of the gold sheet device should be set to the upper position, otherwise the gold sheet device will not automatically rise and fall.
6. The air pressure of the sheet metal device should be appropriate. If it is too small, it can't rise and fall automatically. If it is too big, it is easy to damage the sheet metal device.