Preparations for water pipe cleaning
A set of professional cleaning equipment for Xicun tap water pipeline is specially used for cleaning and preparing citric acid.
Water pipe cleaning construction procedure
(1) Check whether the equipment is in good condition.
(2) Use a clear water bucket to hold water, and put the special pipeline cleaning agent into the water.
(3) Close the main water valve at home (generally installed under the kitchen sink) and the water inlet valve of the water heater.
(4) Remove the angle valve closest to the main water valve, connect the pulse connector of the cleaning machine, put the suction head of the cleaning equipment into the medicated water, and turn on the last faucet at home, just a little. Turn on the water injection switch and inject the medicine into the water pipe for about half an hour. Both hot and cold water pipes need to be injected with chemical water in stages.
(5) After soaking for half an hour, open the main water valve, turn on the air pump and equipment to start flushing the inner wall of the pipeline, and turn on the faucets in turn for cleaning, and each group will be flushed for about fifteen minutes. Cleaning the hot water pipe equipment needs a water inlet, and it needs to be connected with tap water or a pump to pump water to complete the cleaning work.
Precautions for water pipe cleaning
(1) Don't connect the wrong connector, or the equipment will be damaged.
(2) When injecting chemicals, turn on the end tap, otherwise the chemicals cannot be injected and the equipment will be damaged.
Water pipe cleaning is a professional job, and professional work should be handed over to professional cleaning personnel to operate. Improper operation can also damage water pipes.