How to change the battery of Apple mobile phone?

Take Apple 6 as an example:

Preparation materials: Apple 6 original battery or non-original brand battery, sucker, screwdriver, pick, etc.

Apple mobile phone battery replacement, according to the different mobile phone models, the parts that need to be removed are also different. First, disassemble the outside of the mobile phone, and then further disassemble the cable covering the battery of the mobile phone. Be careful when removing cables, and use even force when pulling out battery glue. Finally, after replacing the battery, you need to check whether all the components are installed back.

First, when the phone is turned off, first take out the screws at the bottom of the phone with a screwdriver.

Second, suck the bottom of the phone with a sucker and slowly pull it until there is a gap between the screen and the phone body. Insert the pick into the gap and slowly open the phone body.

Third, slowly pull up the screen of the mobile phone to avoid breaking the screen line.

4. Unscrew the cable cover of the mobile phone screen and the cable cover of the battery with a screwdriver, and remove the cable cover and the battery of the mobile phone screen.

Fifth, slowly pull out the old battery glue with tweezers. Be sure to pull it slowly and evenly, and don't break it. Pull out the adhesive and take out the battery.

6. Stick the back glue of the new battery on the back of the battery, then install it in the battery slot correctly and install the battery wire.

Seven, in turn, according to the disassembly steps just now, install the cable and gland, and fix the bottom screw. The battery will be replaced.

Matters needing attention

1. Because the mobile phone is a precision electronic device, it is recommended to replace the battery at the after-sales point without hands-on ability.

2. Be very careful when unplugging the battery adhesive and disassembling the wiring board, so as not to damage the wiring board.

3. When replacing the wiring board, note that each screw has its own position. Don't install it wrongly, lest the screw penetrate the motherboard.