2. The pulse dust collector has a large working capacity, and the equipment itself is equipped with a pulse dust removal system, so it is effortless to work with large air volume.
3. The pulse dust collector has reliable performance, adopts the pulse controller, has simple circuit, and the width can be adjusted from the first time to the second time.
4. The pulse dust collector box is made of A3 steel, and the cylindrical design box has good strength, low failure rate and extremely convenient installation and debugging.
5. The filter bag of pulse dust collector can generally reach 6 -8 meters, which is about 3-4 times longer than the traditional filter bag, so it occupies a very small area on the ground and saves investment. Because the filter bag is long, the filtering load is high, and the filtering area needed to treat the same flue gas is smaller than that of the back-blowing bag filter, so the equipment has compact structure, less steel consumption and low equipment cost.
6. The pulse dust collector occupies a small area, has almost no noise and has a unique design.
7. It is convenient for the pulse dust collector to check and replace the filter bag. When replacing the bag filter, the operator needs to enter the box to tie the filter bag, and the operating environment is very bad. The installation of the filter bag of long bag low-pressure fast pulse bag dust collector depends on the elastic expansion ring at the mouth of the bag to embed the filter bag into the flower board, without binding or bolts and other connectors. When changing bags, people are on the clean air side above the flower board, so the contact time with the dust bag is short, and the bag changing work is very simple, which saves heavy labor and improves the operating environment of bag changing;
8. The injection pressure of pulse dust collector is low. Because the equipment adopts the straight-through fast pulse valve, the switching speed is fast and the self resistance is small. Therefore, such a long filter bag can obtain good dust removal effect as long as the injection pressure is 0.15-0.25mpa..
9. Pulse dust collector has super dust removal ability. The dust removal intensity of the filter bag is measured by the acceleration of gravity G. The dust removal intensity is usually 35g when reverse blowing is adopted, and it can reach 60 -200g when low-pressure pulse blowing is adopted. It can be seen that the intensity of low-pressure pulse cleaning is dozens of times that of back blowing;
10: the pulse dust collector is like a sanitation worker, which can filter heavy loads well. Because of the guarantee of strong dust removal, even if the dust collector runs at high filtering wind speed, its resistance will not exceed the limit. When used under the same conditions, the filtration wind speed of low-pressure fast pulse bag filter is usually higher than that of back-blowing bag filter, so the low-pressure fast pulse bag filter has a larger treatment air volume under the same filtration area;
1 1: The maintenance workload of pulse dust collector is small. Compared with the traditional pulse bag filter, the number of pulse valves is greatly reduced because of the large ash cleaning area undertaken by pulse valves. Moreover, due to the improvement of diaphragm quality and the reduction of injection pressure, the service life of diaphragm of pulse valve is significantly improved and the maintenance workload is reduced.