1. First, connect the anode and cathode of the solar panel to the PV+ and PV- terminals of the controller respectively. In this way, the electric energy of the solar panel can be input into the controller.
2. Then, connect the anode and cathode of the street lamp to the load+and load-terminal of the controller respectively. In this way, the power output by the controller can be connected to the street lamp to control the brightness and switch of the street lamp.
3. Next, connect the battery anode and cathode of the controller to the anode and cathode of the solar cell respectively. In this way, electric energy can be input from the solar battery pack to the controller for the controller to work and store electric energy.
4. Finally, connect the grounding wire of the controller to the grounding wire of the solar battery pack. This can ensure the grounding safety of the circuit and prevent the circuit from leakage and other problems.
In the wiring process, the following points should be noted:
1. Make sure the wiring is correct and avoid polarity error, otherwise the controller or other equipment may be damaged.
2. Use appropriate cables and connectors for wiring to ensure good cable quality and firm and reliable connection.
3. Before wiring, check whether the circuit is charged to ensure safe operation.
4. After the wiring is completed, conduct necessary tests and inspections to ensure that the controller and street lamp system work normally.
In a word, the connection mode of solar street lamp Putian controller is relatively simple, but it still needs careful operation and safety. Correct wiring can ensure the normal operation of the controller and improve the efficiency and reliability of the solar street lamp system.