Philips three open switch how to connect

Question 1: Philips three open single-control switch how to wire, are confused, the original three open single-control wiring is not the same as the Philips It is very simple with your original is also the same!

You take a short line to the 1 2 3 to parallel access to the firewire! The red one!

The other L11 L21 L31 are connected to the three green control wires!

Question 2: Philips three-open double-control switch how to wire three-open double-control three lights, the numbers inside may be replaced with letters such as LA1\LA2\LA \ LB........ You just have to figure out that those three are a group. Double open single control two lights Two forms of panel . One into the fire separate One **** with.

Question 3: Philips three switches wiring diagram Find an electrician

Question 4: Philips q2 three open double control switch how to wire Hello, the triple double control switch wiring method is as follows.

Switch terminals labeled L1, L2.L3 hole is the public **** end, connecting the firewire,

Terminal labeled L11.L12. the hole connected to the 1 # lamp control line (two holes randomly connected to a),

labeled L21.L22 holes connected to the control line of the 2 # lamps (two holes randomly connected to a)

labeled L31.

Question 5: Philips 3-bit dual-control switch wiring diagram three dual-control three lights face numbers can change letters than LA a \ LA two \ LA \ LB ........ To figure out the three groups double single control two lights panel two forms into the fire ***

Question 6: Philips three switches to control three lights Schematic

Question 7: Philips Q7 three switches wiring diagrams three switch wiring diagrams:

1, the switch terminals labeled L1, L2, L3 of the hole is the public **** end, connecting the firewire, the terminals labeled L11, L12 hole connected to the lamp head line (two holes randomly connected to a). 2, labeled L21, L22 holes connected to the 2 # lamp control line (two holes randomly a) 3, labeled L31, L32 holes connected to the 3 # lamp control line (two holes randomly a).

Question 8: Philips Feiyi switch with three plugs how to wire If the switch is to control the socket, you should first connect the firewire to the switch's L connector, and then use the wire from the switch's other interface to connect to the socket's L connector, the zero line directly to the socket's N connector, the ground line to the ground connector.