2. Be familiar with the operating procedures, use, repair and maintenance in the instruction manual of shot blasting machine.
3. Operators must check whether all switches (including all power switches) in the control cabinet (panel) are in the required setting positions before starting, so as to avoid misoperation, damage to mechanical and electrical equipment and equipment accidents.
4. Non-local operators are not allowed to operate or touch the electric switch control area at will, and are not allowed to get close to the local work area to avoid accidents.
5. Operators must wear protective overalls and protective glasses.
6. When starting the machine, the operator should pay special attention to all kinds of instrument instructions on the panel. Only when all the instrument indications reach the normal value can they operate the small crane (roller table) to enter the process. If it is found that there is a big error (abnormality) in the indication of individual instruments, turn it off immediately. Check the equipment fault handling before normal startup.
7, in the operation of the equipment, the operator must patrol the equipment, check whether there is abnormal noise and overheating. When serious equipment failure is found during operation, press the "Emergency Stop" button to stop for maintenance, and cooperate with professionals to eliminate equipment failure.
8. Operators must carry out daily maintenance and weekly maintenance (including lubrication) of the equipment according to "Equipment Management". Clean up the dust and sundries in the dust collector in time every week, so as not to affect the dust removal quality and ensure the intact rate of the equipment.
9, the operator must be civilized production and safety production at the same time strictly implement the system of succession.
10, immediately cut off the power switch of this machine after work, so as not to make this equipment run. Clean the workplace.