Need to use: sharp-nosed pliers, raw material tape, flush valve, movable wrench. Specific operations are shown below:
1, first of all, the water inlet screw ring unscrewed to take out the water inlet directly head.
2, then the water inlet directly into the mouth of the wire wrapped with raw material tape, raw material tape wrapped 15-20 turns.
3, will wrap the raw material belt outlet connector set screw ring.
4, the wrapped raw material belt of the inlet connector screwed into the inlet, with sharp-nosed pliers against the metal buckle stowaway carabiner tighten the connector.
5, put a good flat washer, set the flushing valve, tighten the screw ring with a wrench.
6, unscrew the spout screw ring, take out the spout tip washer.
7, then put the screw ring on the outlet port, and then put on the pointed washer.
8, and finally the outlet pipe aligned with the outlet of the flushing valve, put on the screw ring and tighten it, then you can.