Liquefied gas pilot pump is improved on the basis of liquefied petroleum gas pump, which can better improve filling efficiency. Of course, efficient work is inseparable from the correct use of methods.
Methods/steps
1/4 Step by step reading
Use the inlet of liquefied gas pilot pump to rush through the gas cylinder, open the angle valve of the gas cylinder, and turn the gas cylinder upside down. If a large steel cylinder has two ports, liquid phase and gas phase, and the liquid phase is connected, the steel cylinder does not need to be inverted. (Preferably, the cylinder outlet is higher than the air guide pump) See if there is pressure on the pressure gauge. The normal pressure is about 2 kg.
2/4
Turn on the rush switch at the pump outlet to discharge the air in the pump for the first time, then open the empty steel cylinder and turn on all switches.
3/4
Test run: Turn the wheel by hand, check whether there are sundries in the liquefied gas pilot pump, start the power switch and test the forward and reverse rotation of the pump.
4/4
Stop the car, cut off the power supply when the empty tank is full, and close all valves.
Matters needing attention
Before use, if the user uses ordinary household dual-circuit electricity, the starting current and voltage must conform to the motor power configured by the water pump to avoid damaging the motor. When the liquefied gas pilot pump is in use, it is forbidden to take time and reverse. If it is pulled out,