How to upload MDX's ECG to your computer?

First, the dynamic ECG instrument's socket is inserted into the com port on the back of the computer. com port interface, also known as the serial port, this is a 9-pin RS-232 interface, the use of serial data transmission is its transmission method,

Hospital medical software installation setup (a) dynamic electrocardiogram

Open the dynamic electrocardiogram software installation file, the file should be as follows There should be the following files

Hospital Medical Software Installation Setup (I) Ambulatory Electrocardiogram

Copy all of the documents in the installation file to your computer's hard disk

Change the file attribute in the installation file from read-only to archive

Hospital Medical Software Installation Setup (I) Ambulatory Electrocardiogram

Copy the "BP" file in the "BP" file to the "BP" file. file "BP_PROU.exe" sent desktop shortcut, specifically "icon properties" ----- "sent to" ------ "Desktop shortcut"

Hospital medical software installation settings (a) dynamic electrocardiogram

The icon on the desktop, an operation as shown in the figure below to change to the correct icon.

Hospital medical software installation settings (I) dynamic electrocardiogram

Click on the changed desktop icon can be used

But check the recorder batteries are sufficient, such as the display of the "B", you should replace the battery in time, install the battery according to the correct pole direction, open the switch next to the battery (ON), cover the back cover. Note: New and old batteries should not be mixed! It is recommended that the batteries be replaced after every two to three patients are measured.

Connecting the computer to the recorder

Remove the rubber cover protecting the data port carefully, insert the round end of the cable into the data port of the recorder, and then hear the "pi" sound and the recorder displays "- - - -", which indicates that the recorder has been connected to the computer. The data cable is inserted into the data port of the data box.

Hospital medical software installation and setup (I) ambulatory electrocardiogram

Open the ambulatory blood pressure analysis software on the desktop, and in the menu of the software, open the "Recorder", "Settings",

This means that the recorder has been connected to the computer. Hospital medical software installation settings (a) ambulatory electrocardiogram

Set the interval of blood pressure measurement

1, the interval of blood pressure measurement (according to the requirements of the hospital) 07:00 - 22:00 30 minutes once

22:00 - 07:00 once an hour

2, click on OK, the software will ask whether to delete the record box data, whether the current time to set the record box data, and whether to set the record box at the current time. The software will ask whether to delete the recorder data and whether to set it according to the current time, click Yes

(Please make sure that the time on the computer using the software is set correctly)

3. After the recorder is set up, immediately disconnect the recorder from the data line and put the rubber cover on. The recorder is ready to display the current time.

4, all installation and setup is complete, you can use it immediately.