1. The bearing of the intermediate cutter is broken.
Check the cause and replace the bearing.
2. The middle cutter is worn.
Both sides of the middle knife have cutting edges, one side can be replaced when worn, and the other side can be used or replaced with a new knife.
3. The pin of the intermediate cutter tube is broken.
Knock out the broken pin with a small punch and install a new pipe pin.
4. The binding force of the baler is adjusted too tightly.
The adjusting nut is provided with an hexagon socket head fixing screw. After loosening, turn the adjusting nut counterclockwise. After adjustment, tighten the hexagon socket head fixing screw.
5. There is oil in slip paper or binding drive belt.
Remove the skateboard to remove oil stains, dry it and assemble it in sequence.
6. The transmission belt is too loose.
The transmission frame seat (boss) can be adjusted downwards or the motor can be adjusted backwards to tighten the belt.
7. The thickness of 7.PP packing belt is too thin or the gap between unwinding rollers is too large.
The gap between unwinding rollers should be only 0.05-0. 1 mm larger than the belt thickness, and should be adjusted according to this requirement.
Extended data
Fault: The steel strip is not cut continuously.
Cause: The cutter is worn or damaged.
Maintenance method: check whether the tool or tool rest is worn or damaged, and replace it if it is seriously worn.
Air pressure reduction
Maintenance method: Check whether the working pressure is normal.
The force for cutting the steel strip comes from the closed cylinder. Refer to the fault phenomenon.
Check blocking operation
Fault: insufficient tension of lock catch.
Cause: The connecting hole or pin of the clamping block is worn.
Maintenance method: Check these parts when the groove depth is shallow, and replace them if necessary.
structural design
1, integrated circuit design: brand-new circuit design, using plug-in circuit board to control the whole packaging action and perm temperature, the circuit board replacement is quite convenient, and the packer service is convenient.
2, instant heating, instant packaging: innovative high-speed hot melt system design, can make the hot plate work within 5 seconds, so that the pet packer can enter the best packaging state.
3. Automatic stop device, which is energy-saving and practical: when the bundling action is completed, it will not run within 60 seconds, and the baler has a compact structure, and the motor will automatically stop and enter the standby state.
4. New brake design:? The binding machine adopts disc brake and special spring design to ensure the smooth and noiseless feeding of the belt.
Baidu encyclopedia-automatic packer