Smashers
Internal cleaning
Smashers need to focus on cleaning up the interior is the inlet, screen, rotor, outlet and other parts of the residual material. Inlet and outlet needless to say, the rotor is installed on the hammer, hammer arrangement is in accordance with certain symmetry to ensure that the entire rotor to maintain a balanced rotation, if not accidentally material residue or stuck in the rotor, will affect the normal rotation of the rotor; as a crusher on the screening equipment of the sieve, controlling the speed of the material and particle size, if the sieve holes are blocked by the material will affect the speed of the material, which will affect the production efficiency. Affect the production efficiency, especially when the humidity of the material is large, the sieve holes are more likely to be blocked, should be cleaned up in a timely manner.
2.
Ring die
Pellet mill internal cleaning
Ring die
Pelleting
machine internal cleaning needs to focus on the feeder
Part,
Moderator
Part and pelleting room part. The feeder is configured with a screw, which is prone to accumulating material; the modulator, because of the addition of steam, increases the humidity, heat and viscosity of the raw material, which is prone to sticking to the inner wall of the modulator, the shaft and the
paddle blades
. The internal structure of the pelleting chamber is more complex and more prone to accumulating material, but the modulator and pelleting chamber of the
pelletizer
are not easy to open, so the frequency of cleaning is recommended to be about 10 days. In addition, there are two cases that must be cleaned up, one is the processing of the formula replacement, should be cleaned up in time to avoid mixing of materials; the other case is a long time not to use the granulator, should be cleaned up in time to avoid residual material deterioration inside the granulator.
3. TCXT series of permanent magnetic cylinder cleaning
Permanent magnetic cylinder mainly clean up ferrous impurities, such as nails. Ferrous impurities are very likely to damage the equipment, so the permanent magnet cylinder should be cleaned every shift, clean down the impurities as scrap.
4. Bag type
Pulse dust collector
Internal cleaning
Bag type pulse dust collector is originally to collect and clean up the dust in the air equipment, after a long time of work, the surface of the bag will be accumulated a thick layer of dust, the end of the shift must be fully cleaned.