Article 1: Equipment, facilities are an important part of the productive forces, is an important material basis for the enterprise to carry out production. Improving the management level of equipment and facilities is of great significance to improve the quality of production, reduce costs, save energy, safe production and improve economic efficiency. In order to adapt to the needs of the company's system reform, according to the "Regulations on the Management of Equipment of Nationally Owned Industrial and Transportation Enterprises" issued by the State Council, and combining with the actual situation of the company, the system is hereby formulated.
Article 2: This system applies to all units of the company's equipment management.
Article 3: the principles of equipment management: relying on technological progress, promote production development, prevention of equipment accidents, management and use of a combination of regular maintenance and regular maintenance, repair and renewal of a combination of professional management and full management.
Article 4: The main task of equipment management: comprehensive management of equipment, keep equipment intact, constantly improve and enhance the technical quality of the company's equipment, give full play to the effectiveness of equipment, rational deployment of the use of good economic efficiency.
Article 5: The company must set up a specialized agency responsible for equipment management, the implementation of unified management of all equipment, unified numbering, clear accounts, accounts match.
Article 6: the company's equipment supervisor is fully responsible for the company's equipment management, 'the company's equipment management policy, objectives to make decisions, and develop equipment management assessment content.
Chapter II equipment planning
Article 7: equipment procurement must strictly implement the company's "equipment procurement procedures and requirements".
Article 8: Equipment installation must be installed by qualified units. Tests and experiments should be carried out and reports issued after the installation. Electrical equipment in hazardous areas are to be installed and modified by professional licensed personnel.
Article 9: the inventory of equipment management should be strict, and a person in charge, to achieve the strict acceptance of the equipment into the warehouse, registration on the books, proper storage, to ensure that the "three good out of the warehouse".
Chapter III Fixed Assets Management
Article 10: The fixed assets of the company's equipment for more than one year, the unit value of 2000.00 yuan and above, by the specialized agencies unified management.
Article 11: the company's production equipment are required to establish equipment accounts, and according to changes in equipment updated in a timely manner, fixed asset cards and equipment and technical files to achieve accurate data, complete technical information.
Article 12: The company's competent department of motorized equipment acceptance, increase or decrease, transfer, scrapping and other good business records, and at the end of the year for field inspection, inventory, so that the account, the goods, the card in line with the problems in a timely manner.
Article XIII: equipment fixed assets accepted into the warehouse, by the competent department of the unified allocation, to strictly implement the equipment deployment, transfer system. Equipment deployment, the original use of the unit must ensure that the equipment is intact, transfer, transfer unit and equipment management unit of the tripartite personnel *** with the acceptance of the handover, after the handover, within one month, if the need for maintenance costs, all into the original use of the unit cost.
Article 14: the use of the unit is not in use and do not need to use the equipment should be cleaned up in a timely manner, maintenance, and reported to the competent department will be idle equipment out of the competent department for deployment, shall not be privately deployed, lending or leasing.
Article 15: the new production equipment shall strictly implement the completion of the acceptance system, the installation department shall provide all the relevant technical information and complete installation of construction records and drawings, the specific acceptance by the competent department is responsible for the acceptance of the original information after the acceptance of the technical file.
Article XVI: special equipment must be in accordance with the provisions of the periodic inspection, inspection, issued by the inspection report.
Article XVII: the innovation and transformation of equipment, should be given to develop technical programs or design, approval by the competent department, such as validation should be recorded in the archives.
Article 18: fixed assets to meet the conditions for scrapping, by the use of the unit to apply for identification of the competent organization, fill out the application for equipment scrapping, reported to the supervisor for approval, has been approved for scrapping of fixed assets should be transferred to the equipment management department for processing.
Chapter IV Use and Maintenance of Equipment
Article 19: Each user unit shall establish and improve the operation, use and maintenance of equipment regulations and job responsibility system, the operation and maintenance of equipment must be strictly observed.
Article 20: The use of the unit should be registered on the unit's equipment, should be implemented to the specific team, individuals, the implementation of hierarchical responsibility, under the responsibility of the unit, to ensure that the equipment is in good condition, improve the utilization rate.
Article 21: Each unit in the use of the process should pay attention to repair, maintenance, improve the quality of equipment personnel, correct use, standardize the operation, and do a good job of routine maintenance, and really do "prevention first" to prevent the occurrence of equipment accidents to ensure that the equipment for a long time to run normally.
Article 22: the need to obtain the mine safety mark of the equipment must obtain the mine safety mark, electrical equipment, knife gate, switch, etc. to have a permanent label.
Article 23: equipment maintenance must seriously implement the prevention-oriented, maintenance and repair and the importance of the policy, seriously implement the principle of unity of use and maintenance.
Article 24: the main equipment to implement the pre-maintenance and pre-screening, its safety devices, a variety of instruments, etc. must be sent to the inspection according to regulations.
Article 25: overhaul, overhaul must be determined on the basis of the actual situation, equipment overhaul should be organized before the preparatory work, overhaul plan reported in advance, serious damage to the equipment, residual value of very small, not included in the overhaul plan.
Article 26: overhaul equipment disassembly, must notify the equipment section for inspection and confirmation for settlement. Overhaul, must carefully fill out the overhaul records, construction record sheets, equipment files and reports.
Article 27: When abnormal situation occurs in the equipment, it must be reported to the competent leader of the unit, and the competent leader of the unit will be reported to the competent department, and the report will be taken level by level, and the abnormal situation will be eliminated in time.
Chapter V equipment accident management
Article 28: equipment accidents directly affect the operation of the production economy, its management must implement the "prevention-oriented" policy, develop effective preventive measures to eliminate major accidents, reduce general accidents. Investigation and analysis, development and supervision of the implementation of preventive measures, proposed accident treatment and statistical analysis of the whole process of management.
Article 29: equipment accidents should be managed by the whole staff, the use of units should be mobilized to all workers, including leading cadres, maintenance workers, operators must participate in equipment accident management.
Article 30: the management of equipment accidents should be dedicated to the person responsible for the accident from the organization of repair, investigation and analysis, the development and supervision of the implementation of preventive measures, the proposed accident treatment and statistical analysis of the report for the whole process of management.
Article 31: Strictly control the failure rate, the occurrence of accidents and hidden dangers of accidents should be reported in a timely manner.
Article 32: equipment accidents, repair should be rapid, the investigation and analysis of its "three do not spare", timely analysis of the causes of accidents, take precautions, the number of accidents, accidents, accident time, accident losses, and other basic data must be faithfully recorded and correct statistics.
Article 33: In the equipment accident management should be carried out in the implementation of rewards and penalties, the implementation of rewards and penalties, heavy rewards and penalties, and the use of the unit and the employee's economic interests, in order to promote safe production.
Sixth chapter of the basic work of equipment management
Thirty-fourth: the company's equipment department should establish and improve the equipment files, equipment drawings and technical data, etc., should be well preserved, and do a good job of statistics, timely and accurate reporting of various types of reports.
Article 35: The archive materials and records should be filled out carefully and accurately, neat and clear handwriting.
Article 36: the use of units, to establish and improve the use and maintenance of the responsibility system, improve the operating procedures, equipment maintenance records, maintenance records, operation records, accident analysis and treatment records.
Article 37: the use of the unit to ensure the integrity of the equipment, equipment is not allowed to operate with disease, not allowed to violate the command and operation, regular training and skills assessment of the relevant personnel to ensure safe production.
Chapter VII By-laws
Article 38: The units and individuals who violate this system shall be assessed according to the "Comprehensive Management of Equipment Assessment Rules".
Article 39: This system is responsible for the preparation, interpretation, modification and supplementation by the maneuvering office.
Article 40: This system shall be implemented from XX to XX.