There is a mnemonic for arranging the wire order from left to right: white orange, orange, white green, blue, white blue, green, white brown, brown. Pinch the neatly cut wire, stuffed into the crystal head, stuffed when the order must not be messed up.
1, use the straight cut position in the center of the crimping pliers to reduce the original crystal head wire. Be sure to cut flush. As shown in the following chart:
2, reduce the head and then extend the reduction to start pushing 3-4 inside the package will be wrapped in the outer skin of the wire cut, peel off the outer skin. As shown in the figure below:
3, peeled off the outer skin of the network cable a *** with 8 fine lines, need to be arranged in the order of white orange, orange, white green, blue, white blue, green, white brown, brown from left to right. As shown in the figure below:
4, row after the front section of the row aligned inserted into the crystal head so that each color of the present can be checked to the head. As shown in the following chart:
5, then the crystal head will be inserted into the crimping pliers, inserted when the feeling of the "snap card", as shown in the following chart:
Expanded Information
Note
If the two sides of the connection is not equal status, then use the parallel (straight through).
If the connection is not equal, then use parallel (straight-through) lines, such as a computer connected to a router or switch;
If the connection of the two devices is equal, then use a crossover line, such as a computer connected to a computer;
All connected to the same is possible, because the general network cable with only 1.2.3.6 other even if not connected to the same can be used.