Get the film need to confirm the film winding direction, find out the counterclockwise direction, and put it on the film rod fixed. (Please turn off the power when wearing the film.) Pay attention to the film before and after the fixed clamps and film tightly combined, such as can not be tightly combined, you need to use a craftsman's knife to film the inner side of the paper tube to cut beveled and then put in.
After wearing the film, use the adhesive tape to stick the film firmly on the receiving paper tube.
The second step, sealing operation steps (panel operation instructions).
Turn on the power, turn on the power switch, the indicator light, set the thermostat to a predetermined temperature, when the green heating indicator light. When the upper hot plate reaches the predetermined temperature, the red thermostat indicator light (sealing machine in the work, the electric heating device in the heating and holding state constantly alternating, so the green and red indicator also constantly alternating display, this is a normal phenomenon).
Put the rubber cup into the lower mold sliding plate, push the lower mold sliding plate into the determined position by hand (if it is a full-automatic sealing machine or automatic sealing machine, the lower mold sliding plate will be entered automatically after putting the rubber cup), press the handle of the sealing machine downward to the maximum stroke, hold the pressure for 1~2 seconds, and then slowly raise the handle and push it to the original position.
Pull out the lower mold slide plate, take out the rubber cup, put in the end sealing rubber cup, and carry on another cycle.