Nowadays, many smokers use electronic cigarette equipment when smoking. So how should we clean the atomizer in the electronic cigarette? The following are the tips for cleaning the atomizer that I have compiled for you. , hope it can help you. Tips for cleaning atomizers
The first method is relatively simple, which is to use hot water. Warm water can also be used, that is, pour an appropriate amount of hot water into the electronic cigarette atomizer, shake it gently for one to two minutes, then pour the water out and blow dry with a hair dryer. This method is the simplest, but it will leave some strong e-liquid flavor.
The second method is to use vinegar. This method is also relatively simple, and vinegar is also a necessity in daily life and is cheap. The specific operation method is to put the atomizer into clean water mixed with vinegar, and then boil it for about ten minutes. Then rinse it again with clean water and blow dry.
The third method is to use Coca-Cola. The specific method is to soak the electronic cigarette atomizer in cola drink. The whole process takes about a day. Then take it out, wash it with warm water, cold water, or boiling water, and finally blow dry the atomizer.
The fourth method is to use vodka. This method is not difficult to operate, as long as you find this kind of wine. The details are as follows: first blow dry the atomizer, then pour an appropriate amount of vodka, seal the mouth of the atomizer with your fingers, and shake gently for one to two minutes, and then pour out the wine in the atomizer. Finally, rinse it with hot water and let it dry. It should be noted that there is no need to blow, and the taste of vodka will slowly disappear. Tips for using the atomizer
1. When filling the atomizer for the first time, drop some e-liquid into the oil guide hole under the atomizer core, and soak it thoroughly before installing and using it to avoid atomization. The core is heated without being completely soaked by the e-liquid, producing a paste smell. But be careful not to drip too much e-liquid to prevent the e-liquid from flowing into the air inlet below and leaking out.
2. When installing the atomizer core, install it in place and tightly to avoid poor contact causing the atomizer to work abnormally.
3. When assembling the atomizer, it should be installed in place and fixed tightly to avoid oil leakage caused by air leakage. At the same time, attention should be paid not to be too careful, which may cause the atomizer to "lock".
4. After assembling the atomizer, do not add too much e-liquid to avoid it flowing into the airway due to pressure and causing leakage. Usually, two-thirds of the e-liquid is filled into the oil tank.
5. The new atomizer core should be filled with oil and left upright for about fifteen minutes. Wait for the e-liquid to completely soak the atomizer core before powering on to avoid burning the atomizer core. The working principles of different atomizers
Jet atomizer: also called jet atomizer and compressed gas atomizer. It mainly consists of two parts: compressed gas and atomizer. The compressed gas is used to move through a narrow opening at high speed and then suddenly pressurized to generate a local negative pressure. The liquid in the container is sucked into the container by another small tube next to the air outlet due to the siphon effect of the negative pressure and discharged. When encountering the high-pressure air flow, it is collided and cracked into small gases. Especially when sol particles encounter baffles in front of high-pressure airflow, the liquid will be collided and crushed to form countless drug particles. The large drug particles fall back to the drug storage tank through the baffle, while the small drug mist particles are output with the air flow.
Ultrasonic atomizer: It uses ultrasonic sound energy to generate vibration and transmit the vibration of the liquid in the container to the surface of the solution through the sound-transmitting membrane at the bottom of the atomizer tank, causing the liquid to vibrate violently. Destroy its surface tension and inertia, thereby forming countless small aerosol particles and releasing them.
Recommendation of atomizer brands
1. Kaiya atomizer
2. Meike atomizer
3. OMRON Nebulizer
4. Oxygen Box (O2BOX) Nebulizer
5. DEVILBISS Nebulizer
6. Ji Rui Atomizer
7.Bairui Atomizer
8.Meilingbao Atomizer
9.Magic Kang Atomizer