A, medical desk and chair use what to pay attention to
1. Prevent direct sunlight, try to avoid outdoor sunlight on all or part of the medical desk, so as to avoid long-term exposure. It should be placed in a place where it can be protected from sunlight, or a bright gauze curtain cloth to block the sunlight, so that it will not affect the lighting and maintenance of the medical desk indoors. Be sure to check the medical table regularly so that it will not continue to be used if it becomes damaged. If the medical table has been damaged, for example, screws are loose, etc., if it is not detected in time, the medical table will be out of use otherwise this will aggravate the damage and if it is serious, the whole medical table will collapse.
2. Inspect the medical table regularly to protect it. When using medical tables and chairs, dust will inevitably be generated on the surface of the medical table. To dust, use a chicken feather duster to clean the dust and then wipe it with a rag. Try to avoid exposing the medical table to moisture or corrosive gases and liquids. In the course of daily work, professionals recommend that exposure of the medical table to humid and corrosive objects should be avoided, as this can easily lead to rotting of the surface of the medical table and damage the integrity of the medical table.
3. If you accidentally pour water on the table while you are working, you should wipe the water immediately with a dry cloth so that the water does not remain on the table and then corrode the medical table. Wipe away rags from medical office chairs and chairs. Take care to use clean rags that do not shed easily. The rags should be soft. Try not to wipe it with a cloth that is too hard or rough or dirty. This may be effective. Prevent the medical countertop from being scratched or contaminated twice. Always use a clean rag to clean the medical table.
Two, medical desk and chair repair method is what
1. Desktop, desktop stain treatment can be wiped with a soft cloth and stained with oil. It can be like new to restore the shine, especially tape viscosity is high, not easy to wipe. Oil is the best cleaner, but it is not good for the skin. Long-term contact should be avoided.
2. Drawers, if the drawers can not slide smoothly, you can buy WD-40 lubricant spray rails at the hardware store. If the drawer surface of the chest of drawers is tilted, you can pull out one-third of the drawer, and you can press down the cabinet on the left and right sides to restore the flat appearance of the drawer surface.
3. Fabric panels, most commonly screen panels, are dirty. You can spray a small amount of stain with 3M Foam Cleaner for about 10 seconds. Wipe with a clean soft cloth. Do not wipe with oil otherwise it will cause fading and marks.
4. Glass panels, wiping the fabric is very difficult. You can use a soft cloth and wipe with old paper. It can keep the light bright, or wipe with a soft cloth so as not to leave the fabric.
It is believed that in the introduction of the editorial everyone for medical desk and chair cleaning and maintenance has been understood. Hospital places are more special, so both purchase and maintenance should pay attention to. I hope that my suggestions for everyone can help.