When connecting a machine with a faucet with a connecting pipe, it is necessary to check the leakage of the pipeline with one key to judge whether the pipeline can be cleaned or not, so as to avoid unnecessary disputes.
Remove the angle valve closest to the main water valve, connect the pulse connector of the cleaning machine, put the suction head of the cleaning equipment into the medicine water, and turn on the faucet at the end of the house. The tap only needs to be turned on a little. Turn on the water injection switch and inject the medicine into the water pipe for about half an hour. Both hot and cold water pipes need to be injected with chemical water in stages. Or confirm that it can be cleaned and make a feasible cleaning plan. Take a bucket of warm water of about 50 degrees (slightly higher than the foot bath temperature, with the ratio of 1: 10) to dissolve the edible citric acid.
After soaking for half an hour, open the main water valve, turn on the air pump and equipment to start flushing the inner wall of the pipeline, and turn on the faucets in turn to clean, and each group will wash for about fifteen minutes. Cleaning the hot water pipe equipment needs a water inlet, and it needs to be connected with tap water or a pump to pump water to complete the cleaning work.
If you soak the water pipe with citric acid, you need to turn on the pumping function by remote control, and inject citric acid water into the water pipe for half an hour to fully soften the dirt on the pipe wall.