The refrigerator is always ice blocked treatment:
1, discharge refrigerant dehumidification method. For serious ice blockage of the equipment, will run with the machine. In the ice blockage has not yet appeared before, with a sharp cut connecting the drying filter end of the capillary tube cut, through the pressure to quickly release the refrigerant. At this time, a large amount of water can be discharged with the fluorine out of the machine. And then through the vacuum, tube wall heating and other measures, you can quickly discharge the water out of the machine.
2, heating method. Fluorine recovery or after the release of the light, and constantly open to improve the compressor temperature rise, and in the freezer and refrigerator room more than a pot of boiling hot water. The condenser is constantly heated with a hairdryer. After a period of time, and then vacuum at the process tube water in the vacuum 30 degrees or so on the boiling gasification. So that the water vapor will continue to pump from the machine, thus over to the machine water out of the purpose of the machine.
3, filter drier method. The compressor will be heated, the drying filter will be connected to the end of the capillary tube, in the capillary tube and filter mesh between the drilling of a 1mm hole, and then heat the drying filter, the moisture will be constantly under pressure in the compressor discharged from the small holes. The process pipe is constantly fed with new air dried by the filter drier. Then change the new filter.
Expanded information:
Avoid refrigerator ice blockage approach:
1, we should always check the sealing of refrigerator seals, if the sealing of the sealing of the sealing of the sealing of the sealing of the sealing of the sealing of the sealing of the sealing of the refrigerator. Deformation, it will affect the degree of closure of the tight fit, resulting in cold air leakage, thereby increasing power consumption. If the deformation is serious, should be replaced in a timely manner.
2, regular defrost: refrigerator use for a period of time, will produce some frost, if you can not regularly frost, then it will affect the refrigeration effect, and power consumption will also increase, and even easy to damage the compressor. Therefore, whenever you see the thickness of the frost more than 7cm, you should defrost.
3, reduce the number of times you open the door: Whenever you pull open the door of the box, there will be cold air exposed, hot air invasion, so you have to run the compressor again refrigeration. Therefore, try to take out a variety of ingredients needed, and move quickly, the box door should not be pulled open at too great an angle, as far as possible to reduce the loss of cold air.
Reference: