How much is the water purification equipment consumables?

Solution for troubleshooting of large-scale pure water equipment 1. When the water is full, the machine beats repeatedly. If this fault occurs in pure water production equipment, there must be pressure leakage in the system. The first possibility is that the pressure of raw water is insufficient, the second possibility is the pressure relief failure of check valve, and the third possibility is the failure of high-pressure switch. These failures will cause the machine to trip repeatedly after the water is full. 2. When the pressure barrel is full of water, pure water will not flow out. At this time, it is necessary to check whether the ball valve of the pressure barrel is damaged or whether the pressure barrel has a pressure relief fault. At the same time, if the rear activated carbon is blocked, this kind of fault will also occur. 3. There is a serious imbalance between waste water and purified water. In this case, first check whether the flushing solenoid valve is faulty or damaged. Secondly, check the waste water proportional mixer. If it is too conductive or too blocked, it will lead to failure. Finally, it is ruled out whether the filtration speed of reverse osmosis membrane is seriously reduced due to its blockage.