Ozone equipment operation use to pay attention to what things?

I. Daily maintenance of ozone generator sterilization equipment

1, the ozone generator should always be placed in a dry and well-ventilated clean environment, and make the shell reliably grounded. Ambient temperature: 4 ℃ -35 ℃; relative humidity: 50% -85% (non-condensing state).?

2, ozone generator maintenance, maintenance must be in the case of no electricity, no pressure.?

3, regularly check the electrical parts of the moisture, insulation is good (especially the high-voltage part), grounding is good.?

4, if found or suspected that the ozone generator is damp, the machine should be tested for insulation and drying measures. Must be in a condition to ensure good insulation before starting the power button.

5, regularly check whether the vent is smooth and covered. Do not block or cover the vents.?

6, ozone generator each continuous use of time general maintenance more than 4 hours.

7, ozone generator use for a period of time, you should open the shroud, with alcohol cotton to carefully remove the dust in it.?

8, long-term shutdown, please cut off the power supply.?

9, flammable and explosive places with caution.

II. Ozone generator sterilization equipment when using the precautions?

1, oxygen-type ozone generator should pay special attention to the use of nearby open flames, to prevent oxygen explosion;?

2, ozone generator ozone discharge tube should generally be replaced once a year;?

3, ozone drying system desiccant must be replaced every six months;?

4, the ozone generator will be placed in a ventilated dry place, once the environment around the machine is humid will leakage, the machine can not operate normally;?

5, if the cooling water into the ozone generator should be immediately shut down, the discharge system is completely disassembled, replace the discharge tube, desiccant;?

6, the ozone generator can not be inverted during transportation, before running must check whether the instruments are intact;?

7, the regulator in the process of regulating the voltage should be gradually boosted, never directly to 15000V.