Most products on the market are made of aluminum alloy, even iron, while the Outlander electric dryer is made of titanium-magnesium-aluminum alloy, which is mainly used in mainframe, lifting frame components, clothes drying rods, shelf components and so on. Titanium-magnesium-aluminum alloy has low density, light weight, high strength, good corrosion resistance, good plasticity and high strength, and is generally used in aerospace field.
How to identify? A small magnet can recognize it, but a good Ti-Mg-Al alloy cannot be sucked in.
Then look at the surface technology of the electric dryer.
Common in the market are painting, dusting, electroplating/electrophoresis and baking paint. The cost of painting is low, but the color is uneven, which is easy to produce gap bubbles; Powder spraying is better than spray painting, but it requires higher raw materials, has a weak sense of color and is slightly low-grade; Electroplating electrophoresis process has good scratch resistance but poor durability, which will fade after long-term use; Baking paint technology is the highest cost and the best quality among the four surface treatment technologies. The surface treatment technologies of Apple mobile phones and high-end cars all adopt baking paint technology. Outlander electric dryer adopts three-coating and three-baking baking paint technology, which is scratch-proof, discoloration-free, colorfast and has strong oxidation resistance.
How to distinguish the surface treatment process of electric dryer? Under the light (which can be illuminated by mobile phone), the paint surface is smooth, without orange peel, protrusions, gaps and bubbles, full of color, strong color sense and mirror phenomenon.
Another thing you can see about surface technology is the hole in the air drying rod.
The clothes racks on the market are similar, but this inconspicuous detail can reflect a brand's extreme attitude towards products and user experience. For example, some holes will be blocked by rubber or plastic. Ostensibly for the safety of users. In fact, it covers up the defects of the punching process, and the ring of the hole is easy to fall off. If it falls off, you can look at the processing technology of the hole edge. The rod of Outlander electric dryer adopts advanced punching technology, which is directly molded, with no burr on the edge and no clamping sleeve, so users don't have to worry about scratching their hands.
Followed by wire rope.
The market is basically 7x7 commercial 304 steel wire rope, which can bear load, but its durability, oxidation resistance and corrosion resistance are slightly poor. The steel wire rope of Outlander electric dryer cooperates with Sinosteel, and adopts 7x 19 strands of aerospace military 304 steel wire rope, which is soft, will not rust, and its corrosion resistance is three times that of commercial 304.
How to distinguish the quality of wire rope? At the store site, ask the clerk to demonstrate for you. Take a steel wire rope and wind it tightly around your finger or other tubular objects 10-30 seconds to loosen it, and observe whether the steel wire rope will automatically recover. If the wire rope automatically returns to its original state without bending deformation, it shows that the quality of the wire rope is good.
What you can see on the surface is light.
Here is just a common sense for everyone. The brighter the light, the better. It can be adjusted by frequency converter. It's like running. According to your usual physical strength, you can only run 1000 meters, and suddenly let you run 3000 meters. Overloading running is actually bad for your health. The same is true of lighting. Lighting overload will reduce the service life of lighting. This is why the lights of the Outlander electric dryer are softer than those of other brands.
The content is taken from Baidu experience:/article/3EA51489baed252e61bba03.html.