1. First, we turn off the computer, take out the battery and make sure that the computer is not powered on.
2. The original hard disk of 2.T430 is in this location, as shown in the figure. We just need to use a screwdriver to remove this screw, remove the outer box (the screw is closely connected with the parts, and the shell can be removed slowly after loosening the screw), and loosen the only screw that is circled on the way (the hard disk cover). Note: The screw cannot be removed.
3. After removal, as shown in the figure.
4. The black drawstring circled in the picture below is placed in the upper and lower gaps of the hard disk by default. Take it out and pull it out from the hard disk.
5. Take out the original hard disk as shown in the figure (the strips on both sides are rubber pads).
6. Loosen the screws on both sides and remove the fixed hard disk from the bracket, as shown in the figure.
7. Install the SSD on the bracket and fix the rubber pad, as shown in the figure.
8. Just install it, as shown in the figure.