The processing capacity of adsorption dryer is the maximum flow rate of compressed air that can be processed by the equipment, which is generally expressed by cubic meter per minute (m?/min), and the maximum processing capacity of a single equipment is 120m?/min.
The minimum processing capacity of adsorption dryer is 1 cubic meter per minute (m3/min) as the design standard.
That is to say, even if the volume of gas used is less than 1 cubic meter per minute, you can only buy the equipment with this processing capacity.
Processing capacity model differentiation Taiwan DPC
The processing capacity of the adsorption dryer will fluctuate according to the compressed air pressure, for example, the same model, at 5 kg pressure, can handle a flow of 5m3/min, while at 10 kg pressure, can handle a volume of 6.5m3/min.
Below is the model differentiation corresponding to the handling capacity of a modular adsorption dryer:
Handling capacity of adsorption dryer
Below is the model differentiation corresponding to the handling capacity of a twin-tower adsorption dryer:
We can find out that the maximal handling capacity of a modular dryer is much smaller than that of a twin-tower dryer.
This is because the modular dryer covers a smaller area, more convenient transportation, installation, in the face of a large processing capacity, you can choose more than one model side-by-side combination of use.
How to choose the right capacity for your plant?
Most people know to choose the right adsorption dryer according to the air supply of their air compressor, and they would rather choose a smaller one than a bigger one.
As a manufacturer of adsorption dryer, we are here to tell you responsibly, if the air consumption is large, try to choose the big one of the adsorption dryer, the reason is because in the face of high temperature and high humidity weather, the air moisture content increases, the adsorbent effect decreases, and the equipment will be loaded at this time, resulting in the end of the use of large amounts of moisture, equipment failure and shutdown, and other serious problems.
Adsorption dryer failure
In August-September 2018, the country's torrential rains, more than half of the factories have frequent equipment failure downtime, a large amount of water at the air-using end.
With severe weather becoming more and more frequent, it is very necessary to choose the big one. As adsorption dryer manufacturers, should also actively recommend that users choose a large number of adsorption dryer processing capacity.