1, water change and tank cleaning (it is recommended to clean the tank and replace the circulating water once a week)
Note: The machine must be guaranteed to be full of circulating water in the laser tube before work.
Circulating water quality and water temperature directly affects the service life of the laser tube, it is recommended that the use of pure water, water temperature control below 35 ℃. Above 35 ℃ to replace the circulating water, or add ice to reduce the water temperature, add water (cooler, it is recommended that users choose or use two water tank).
Cleaning the water tank: first of all, turn off the power, remove the inlet pipe, so that the laser tube automatically into the water tank, open the water tank, pumping to remove the dirt on the water pump. Clean the water tank clean, replace the circulating water, restore the pump back to the water tank, insert the connecting pipe into the water inlet of the pump, organize the joints. Use the pump power alone and run it for 2 to 3 minutes (the laser tube is full of circulating water).
2, fan cleanliness
After a long time of use, it will cause a lot of solid dust to accumulate inside the fan, allowing the fan to make a lot of noise, in addition to the smell, is not conducive to exhaust. When there is insufficient suction fan smoke is not good, first turn off the power, the fan will be discharged into the air ducts and air ducts, to remove the dust inside, and then install the fan, pull out the air ducts inside. blades until it is clean, then install the fan. Then it can support the co2 laser machine to work normally.
3. lens cleaning (it is recommended that every day before going to work, cleaning equipment off)
The previous introduction to the machine, spoke of the engraving machine has 3 pieces of reflector and 1 piece of focusing mirror (1 reflector in the laser tube, the exit is in the upper left corner of the machine, the reflector is in the left beam of the #2 and #3 mirrors in the top of the laser head of the fixed portion of the laser is located in the laser focusing mirror in the lower part of the adjustable mirror tube), after focusing the The laser light is reflected by the lens and ejected from the laser. The lenses can easily come into contact with dust or other contaminants, causing loss or damage to the laser lens, no. 1 and no. 2 do not have to be removed, cleaning the lens needs to be dipped in cleaning fluid cleaning lens paper, along the center of the lens on one side of the edge to the direction of rotation carefully wipe. 3, the lens and focusing lens from the frame, wipe in the same way, wipe the same after the completion of the return connection.
Note: (1) the lens should be gently wiped, do not damage the surface coating;
(2) should be removed and gently wiped process to prevent falling;
(3) focusing lens mounting please be sure to keep the concave side down.