Methods:
1, for low-voltage electrocution, if the electrocuted person touches the voltage charged device, the rescuer should try to quickly pull the power switch or power plug, or use the insulated handle of the electrician's pliers to cut off the power supply.
2, when the power line is connected to the electrocuted person or is under pressure, can be dry clothes, gloves, sticks and other insulating materials as a tool, pull away from the electrocuted person or pick open the wire, so that the electrocuted person from the power supply.
Precautions:
First, the rescuer should not be electrocuted himself (i.e., can not directly grasp the panel of the electrocuted person with his hands, can not grasp the wire *** part).
The second is to prevent the electrocuted person from falling after getting off the power.
What are the precautions for removing the electrocuted person from the power source?
The two most important points: First, the rescuer should not be electrocuted (that is, not directly grasp the panel of the electrocuted person with his hands, can not grasp the wire *** part of the second is to prevent the electrocuted person from falling after the power supply
What are the methods to make the electrocuted person off the power supply, in the first aid of electrocution, so that the electrocuted person off the power supply, what are the methods, respectively, briefly describedMake the electrocuted person off the power supply ⒈ low-voltage from the power supply Methods: ①, "pull": the nearest pull open the power switch, dial out the pin-type porcelain plug insurance, ②, "cut": with an insulated handle insulated tools to cut the power cord, ③, "cut": With a dry handle of the axe, pickaxe, hoe to cut the wire, ④, "pick": with a dry stick, bamboo poles, etc. to pick open the electrocuted person on the wire, ⑤, "pad": with insulating materials under the electrocuted person, so that it is away from the power supply, ⑥, "Tugging": use insulating materials to pull the electrocuted person away from the hand. Pake high voltage from the power supply method: ①, use the same insulation level tools to disconnect the power supply, ③, notify the power supply department to stop the power.
What methods can be used to make high-voltage electrocution from the power supplyHigh-voltage electrocution is the best way to deal with the blackout, you can also use the voltage level of the insulated tools to make the electrocution from the power supply, the operation of the person to wear insulated boots and wear good insulated gloves.
Low-voltage electrocution can be used to make the electrocuted person from the power supplyUse non-conductive objects, such as dry sticks, etc. will be part of the electrocution from the power supply. Never pull by hand, or you will be electrocuted together
When you find someone electrocuted, what methods are used to remove the electrocuted person from the power source as soon as possible?When someone is electrocuted, the person next to him should not panic, and should take the following emergency measures in time. (1) First of all, we must quickly pull off the power switch or unplug the power supply, not to pull the body of the electrocuted person with their hands. Because the electrocuted person is electrified, must be removed from the power supply as soon as possible before rescue. (2) In order to buy time, use dry bamboo poles, stretcher, or wooden sticks to dislodge the electric wires or electrical appliances on the electrocuted person, and never use iron or damp sticks to prevent electrocution. (3) The rescuer can stand on a dry board or wear rubber-soled shoes without nails, and use one hand (never use two hands at the same time) to pull the dry clothes of the electrocuted person, so as to make the electrocuted person get away from the power source. (4) people in high places electrocuted, to prevent from falling from a high place to fall after the power supply.