Standard chemistry laboratory construction and management program According to the relevant requirements for the use and management of standard laboratories to meet the chemical research on the operation of the plant project, specially formulated laboratory construction and management program is as follows: a. Laboratory construction 1, the basic requirements of the laboratory and auxiliary room internal facilities: general requirements for the establishment of laboratories, drug Instrumentation room, the lab technician office.
Laboratories and ancillary rooms should be set up according to its functional requirements of water supply and drainage, ventilation system, a variety of power outlets and total power control switch, and install leakage protector. New or newly renovated laboratory should be renovated before a laboratory overall planning and design drawings, according to the specific needs of the laboratory, labeled with the corresponding on the water, water; power; exhaust, etc. location, so as to avoid the emergence of the experimental renovation of water and electricity and other lines to go to the situation of the open wire.
(These designs can find a professional company to do.) Laboratory requirements for water, electricity in place, with a 220V two-hole, three-hole socket each two or more, laboratory ancillary rooms in the model room, hanging room, sample room, maintenance room, laboratory office can also be located in the instrument room or preparation room, laboratory office shall not be located in the chemical laboratory.
2, chemical laboratories and pharmaceutical instrumentation room should be set up floor drains, water supply and drainage in place. Laboratory, instrument room should be appropriate anti-theft, fire safety facilities, independent storage of dangerous goods, protective equipment and first aid kit.
Chemical laboratories are equipped with ventilation devices. The center of the ventilation device is not less than 300mm from the ground, the indoor vent side should be set up to protect the cover, the outdoor side of the wind should be facilities.
Chemical laboratories, drug rooms (cabinets) should be installed automatic (forced) ventilation, exhaust system. 3, chemical laboratories should be supplied with water to the table, the table appearance of the body neat, desktop to the downpipe is not exposed.
Chemistry laboratory experimental table should be set up gooseneck faucet. Chemistry laboratory water shall be used with a gooseneck faucet.
Chemistry laboratory requirements for power installation to the table, and the addition of electric shock security device protection, in principle, to set up a three-phase, four-wire 380V power outlets, and equipped with an independent fuse; laboratory table fixed and clean appearance. Indoor power lines and power outlets installed in a scientific and standardized manner, do not take the open line, power outlets fixed (or embedded) in the experimental table.
And automatic (forced) fume hoods. Chemical laboratories should be divided into instrument rooms and drug rooms, chemical laboratories should be equipped with eye washers, or stainless steel combined emergency sprinkler.
4, laboratory tables, instrument cabinets, basic requirements: laboratory tables, instrument cabinets, the basic dimensions of the requirements of uniformity, standardization, practicality and aesthetics. Instruments, medicine cabinet size should be based on the function and storage requirements of the unified design, the number should meet all the equipment storage needs.
Second, the standard of experimental teaching instrumentation according to the experimental needs of special experimental instruments, perishable instruments to have spare. Third, the construction of the experimental personnel team according to the need to equip the number of experimenters, and designate the person in charge of the laboratory, need to have a certain level of professional theory and experimental experience.
Reasonable workload standards for laboratory staff. Laboratory staff should love their jobs, familiar with the experimental requirements and can standardize the operation, can independently complete all the experiments, have a strong sense of enterprise, experimental ability and management ability, understand the nature of dangerous drugs, standardized storage, familiar with the management of experimental drugs and instruments business.
Fourth, laboratory management The laboratory must establish complete work norms and work system. Laboratory personnel have clear responsibilities, the establishment of instruments and equipment custody and use of the system, laboratory rules, experimental management system, the purchase of instrument damage records, safety and security and hazardous materials management system, and strictly enforced.
Laboratory rules should be posted in the laboratory in a conspicuous place, the rest were posted in the lab technician's office. 1, sound books (general ledger, ledger, low-value consumables account), timely and accurate records, "general ledger" filled out once a year; experiments in the number of instruments to increase or decrease log in the "ledger"; glass instruments, drugs, increase or decrease in a timely manner into the "low value consumables account", and accept financial supervision.
Do a regular inventory, accounts, accounts match, accounts match, accounts, cards, things match rate of 100%, low-value consumables accounts, things match not less than 90%. 2, instrumentation management is scientific and reasonable.
Laboratory instruments and equipment must be all in the cabinet, categorized and stored in a reasonable row (or according to the instrument number or by the order of experiments), the positioning of the cabinet; and according to the heavy under the light on the horizontal or vertical placement of the principle of appropriate adjustments, the special high special large instruments set up a special cabinet; to achieve a scientifically rational, beautiful and easy to access. The purchase of chemical reagents to have a plan, the classification should be stored correctly and reasonably, pay attention to avoid light.
Highly toxic drugs and flammable drugs must be in the hazardous materials library. 3, to ensure that the cabinet instrument at any time in a usable state.
Teaching instruments and equipment should be regularly maintained, timely maintenance, and according to the different requirements of the instrument to do a good job of power, dust, moisture, rust, corrosion; chemical reagent bottles clearly labeled, intact; the end of the experiment should be used to carry out the necessary inspection of the instrument, the maintenance of the cabinet. Every year on the existing instruments and equipment for a routine maintenance, integrity rate should reach 100%.
4, spare experimental equipment can be separately boxed, the list of ready to use, worn out equipment timely scrapped. Toxic, flammable, explosive and other hazardous materials should be in accordance with the relevant provisions of public security, fire, environmental protection and other departments for safekeeping, use, and strict implementation of the hazardous materials receipt, management system.
5, the laboratory, instrument room, preparation room should always keep clean, pay attention to ventilation, proper disposal of "three wastes" (waste gas, waste liquids, waste products), to provide a good experimental environment, to protect the health of laboratory personnel to ensure experimental safety. 6, adhere to the completion of the "Laboratory Logbook"; pay attention to the accumulation of information, such as work plans, minutes of meetings, summaries (with relevant information).
8, there is a complete management and collocation system for dangerous goods and drugs, and strictly enforced. Minimize the occurrence of major accidents in the laboratory.
Shenyang Pengfeng Laboratory Design Co., Ltd - laboratory overall program solution experts, is a set of overall laboratory design, decoration, sterile laboratory, gas piping, ventilation system services, professional company, the main products include laboratory bench, fume hood, medicine cabinet, gas cylinder cabinet, etc., laboratory instruments, scientific equipment, Bioengineering equipment, medical equipment, analyzing and testing instruments, laboratory sample processing instruments, online monitoring instruments, chemical reagents, consumables and so on. The company has.
2. What are the contents of the laboratory construction project
The contents of the laboratory construction project:
1, the environmental automatic monitoring (control) system
The environmental automatic monitoring (control) system is built to set the water, gas, pollution sources and related environmental monitoring information processing system XX environmental automatic monitoring (control) system. Exceeded the SO2 automatic monitoring of waste gas pollution sources and mobile monitoring station monitoring, information processing, etc. into the environmental information processing system, and ultimately built a set of water, gas, pollution sources (wastewater, waste gas), information processing and dissemination, and auxiliary decision-making in one of the "XX environmental automatic monitoring (control) command center. Center control by the environmental laboratory.
2, the ambient air automatic monitoring system
Reflects the XX ambient air quality conditions, trends and changes in the pattern of change, the degree of improvement in ambient air quality, the formation of regional air quality forecasting capabilities. Ambient air automatic monitoring system management and maintenance group is located in the environmental laboratory.
3, XX water quality automatic monitoring system
Water quality automatic water quality monitoring station warning outlet water quality. Management and maintenance group is located in the environmental laboratory.
4, XX pollution sources automatic monitoring system
COD emissions pollution sources to install COD online monitor, pH meter, sewage flow meter, equal proportion sampler. Network monitoring. Management and maintenance group is located in the environmental laboratory.
5, monitoring information system
The laboratory is responsible for monitoring information system management. XX the actual state of the environment will be information technology, networking, automation, digitalization as the direction of development, unified-planning, design, step-by-step implementation of distributed, hierarchical environmental monitoring information system for environmental management and decision-making, to provide timely and convenient information Support. Combined with environmental monitoring information, LIMS and other decision-making and management support system construction work, will set up environmental monitoring database and related information data warehouse.
Management of environmental monitoring external website, according to the data information released environmental monitoring information, environmental quality information, the establishment of *** enjoy environmental monitoring database.
6, focusing on environmental environmental monitoring, in the training of enterprise technical backbone at the same time, and actively learn from the experience of open laboratory construction, and actively introduce and cultivate their own technical backbone, so that the laboratory's disciplinary configuration is more reasonable, around the creation of the State Key Laboratory, the establishment of an open platform for academic exchanges, focusing on prospective research projects with the help of the "outside brain "Research, and domestic and foreign enterprises and technical organizations to establish extensive contacts.
3. Laboratory room construction planning and basic procedures are how
In fact, laboratory construction is different from the construction of ordinary houses, laboratory construction to take into account all aspects of the construction, the technical more prominent, so before the construction of the complete planning program we must make before the implementation of the current Baonuo based on the years of experience of the laboratory of the technicians summed up the complete implementation of the program < /p>
According to the different test items, the test equipment for classification, the formation of different test items can be carried out at the same time a few areas, giving each area a certain functionality, maximize each area can be completed independently of the specific function. If two or more than two unrelated test items, in the same test area for testing, and in the detection process of interference between each other, then this shows that the function of the test area has not been reasonably allocated.
Shenzhen Baonuo Experiment Co., Ltd. for your answer, I hope to help you