1, material tray installation: insert the inner tube into the outer tube, cut the grille opening, grille through the hinge and the bottom of the tray connection (pay attention to the direction of the twisted, narrow side of the alignment of the opening, gently press can be), will be mounted on the previous step of the tube into the material tray and tray buckle, pay attention to the teeth and holes in each to be matched with a good. Attach the switch holder and switch plate to the tray, so that the entire tray assembly installation is complete.
2, the material tube installation: the material tube hole at the positioning piece with pliers gently turned outward, folded into 90 degrees, do not break. The hole of the inner cylinder of the material disk is aligned with the flap on the material tube (only one can be aligned). Place the disk head close to the mounting and press firmly so that the lone portion of the disk head is tightly pressed against the outer wall of the feed tube. Gently push the pan head so that the barbs of the pan head fit well in the inner tube. Push the disk head with the female finger of both hands, hook the inner tube with the index and middle fingers, and gently pinch with both hands to complete the installation. After the material pipe is mounted on the material tray, connect it along the direction of the material line and fix the material pipe with the clamp, don't lock the clamp when connecting, when the whole material line is installed, adjust the material tray while locking the clamp, require the material line to be straight and the clamp not to loosen, connect and fix the front end of the material line with the main body of the material box, and connect and fix the end of the material line with the connector of the motor.
3, lifting system installation: lifting winches fixed in the chicken coop beam, such as brick and wood tile structure, can be fixed with hoops or screws, such as steel chicken coop, can also be mounted pads welded to the steel beams, and then fixed with screws.
4, the installation of the winch: winch to be placed in a dry place to prevent rust, before the installation of the winch to verify that the specifications of the installation of the length of the winch and the installation of the same length, do not over-bend the installation of the winch, to prevent it from producing plastic deformation. Insert the stringer from the end of the material box to the material pipe until the stringer rises to the motor position at the end of the material line, install the shaft protection ring on the motor shaft, set the stringer into the motor shaft, and lock the stringer with the fixing hook or the spring clamp card (a couple of shaped cards). Lock the motor to the motor connector.