How to change the password of Baotailai fingerprint safe?

1. Open the door with a password:

Step 1: Keep pressing the "1" key 2S until a long "beep" sound is heard, indicating that the keyboard has been started;

Step 2: Enter the remaining 10 digits of the unpacking (cabinet) password continuously. If the input is correct, make a long beep and turn the handle to open the door;

Note: If the beep is shortened four times and the red light flashes twice, you must re-enter the unpacking (cabinet) password. If the incorrect password for unpacking (cabinet) is entered for 5 consecutive times, the buzzer will give an alarm for 30 seconds and the password opening function will be disabled for 5 minutes.

2. Module initialization

First, open the safe and disconnect the power. At this time, you need to press the "0" key to discharge, and then press and hold the initialization switch. After turning on the power for 6 seconds, you will hear two long "beep" sounds, and the green light will be on twice. Then, with a beep, the green light came on and the initialization was successful.

Three. Register super fingerprint

Step 1: The module must be initialized first. After successful initialization, press and hold the initialization switch for 3 seconds. When you hear a long beep, the green light is always on, and then release the initialization switch.

Step 2: Press the "0" key to start the machine, the fingerprint window will flash, and the buzzer will respond synchronously and make a short beep. Within 5 seconds, put your finger in the fingerprint window to register the super fingerprint. The green light flashes once, and the beep is long, indicating that the input is successful for the first time. Otherwise, the beep is short twice and the red light flashes twice, indicating failure;

Step 3: Then wait 1 sec, the fingerprint window light flashes again, and the buzzer synchronously responds with a short beep. You should input the same fingerprint for the second time within 5 seconds. If the beep is twice long and the green light goes out at the same time, the registration is successful; Otherwise, if the buzzer sounds four times shorter and the red light flashes four times to indicate a fault, the above operation should be repeated;

Note: After successfully registering the super fingerprint, the factory door opening password will automatically become invalid; Super fingerprint and ordinary fingerprint cannot be set with the same finger, so as not to cause unnecessary confusion.