Dauda unmanned scrubber accessories replacement steps and traditional scrubbers are the same, the specific operating steps are as follows:
Unscrew the two ends of the fixing screws, unplug the sewage suction pipe, the entire suction grill from the scrubber body unloaded;
2. Unloading the middle of the suction grill two screws, loosening one end of the suction grill adjusting screws, to facilitate the accessories to unload;
3. Unloading the Remove the metal clip, and both sides of the inside and outside of the water-absorbing adhesive strip;
4. Install the new water-absorbing adhesive strip on the suction pickup, water-absorbing adhesive strip on the holes aligned with the water-absorbing pickup on the clips. Pay attention to the distinction between the two sides of the water-absorbing adhesive strip, the inner strip edges are serrated, the outer strip edges are flush and non-serrated;
5. After installing the water-absorbing adhesive strip, the unloaded screws to return to the position of the metal clamps to return to the position of the adjusting screws to ensure that the fittings are fixed.
6. Finally, replace the glue strip of the suction steak back into the scrubber, the two ends of the screws into the slot, tighten the screws, insert the sewage suction pipe.
Note: 1. Replacement of attention to distinguish between the inner and outer suction glue, serrated inside, no serration outside;
2. Installation of glue and fixed metal clamps pay attention to the alignment of the suction steak on the buckle.