Effective at the same time, in accordance with this should not occur,
First check the X-axis negative proximity switch whether the action,
Then take a look at the machine tool parameter settings, modify the soft limit.
Fangjun Welding & Cutting suggests that it is best to find a professional to take a look, or make a mistake and crash the machine.
1 Cutting effect is not good or cut through?
Power settings are small, potentiometer screwed small, light bias, dirty lenses, focusing lenses installed in reverse, focal length, laser power supply, laser tube power attenuation, water temperature is too high, voltage instability, etc. Determined according to the actual situation, by the simple as deep.
2 Connected to the device ?
Whether to install the board driver, USB cable or network cable is plugged in, USB cable or network cable is bad, bad adapter boards, boards, etc.
3 boot back to the origin of the movement in the opposite direction ?
Bad home switch
4 Cutting graphics distortion and cutting overlap ?
Synchronous wheel screws loose, motor wire broken, motor bad, drive, voltage, etc..