1. Selection of basic mode of weighbridge remote controller. The remote control of the scale is usually in "normal condition" mode and has power-off memory function. If you change to other modes during use, press the OFF key after use, and the remote controller of the ground scale will immediately return to the normal mode. The setting of the weighing unit can be operated according to the instructions.
2. Calibration: After the installation of the remote control of the ground scale, the remote control of the ground scale should be calibrated before each use. Due to the long storage time, moving position, environmental change or no measurement, the weighbridge remote control is generally calibrated before use. The remote controller of this weighbridge remote controller adopts external calibration (some electronic weighbridge remote controllers have internal calibration function), which is completed by TAR key clearing, CAL subtraction and 100g calibration weight.
3. Peeling and weighing, press the TAR key to reset, put the container on the weighing plate, the weighbridge remote controller displays the container quality, and then press the TAR key to display zero, that is, remove the tare weight. Put the weighed object into the container again, or gradually add the weighed object (powder or liquid) into the container until it reaches the required quality. When the "0" in the lower left corner of the display disappears, the net weight of the weighed object will be displayed. After all the items on the weighing plate are removed, the remote control of the scale will display a negative value. Press the TAR key, and the remote controller of the weighbridge will display 0.0000 g. If the total mass on the weighing plate exceeds the load during weighing (FA 1604 electronic weighbridge remote controller is 160 g), and the remote controller of the weighbridge only displays the upper line segment, the load should be reduced immediately.