One: Chongqing Baiji water heater repair common failures
1. Water heater heating process, the safety valve small holes have water droplets dripping out. This is due to the electric water heater belongs to the closed storage type electric water heater, in the heating or insulation process, the water heater liner water pressure is greater than 6Mpa, so that the one-way safety valve overpressure and dripping water droplets. You can close the water inlet valve, the mixing valve knob to the high temperature can be avoided one-way safety valve leakage phenomenon, so that the water drips from the shower. If the mixing valve is not installed, you can open the hot water ball valve a little bit, where the pressure relief water, you can also avoid the leakage of the one-way safety valve.
2. The hot water heater in the hot water use time is short, because the first time to use the water heater (or there is a section of the realm is not used from the new use) due to the water heater heating time is short, the upper and lower levels of the water temperature is not uniform, resulting in a small amount of hot water. Must continuously use the water heater to work for more than 12 hours, so that the water temperature in the water heater up and down evenly.
3. Water heater leakage during use, which is a very serious failure to pay attention to often. It is caused by: ① air pressure switch is not properly adjusted. ② Inappropriate position of the suction nozzle. ③Silicone tube falling off or cracked, resulting in leakage and loss of pressure can not promote the wind film. ④ The wind pressure switch is out of order. ⑤Pulser failure. The solutions are: ① Adjust the wind pressure switch to the appropriate position. ② Adjust the suction nozzle. Insert or replace the silicone tube. Replace the air pressure switch. ⑤ Replace the pulser.
4. The heating indicator light is on, but can not be heated.
It is because of ① poor contact or broken wire at the plug end of the heating tube. ② heating tube burned out. Solution: ① check to exclude. ② Replace the heat pipe.
5. Heating indicator does not light and can not be heated. Reasons: ① thermostat plug poor contact or broken wire. ② thermostat burned out solution: ① check to rule out. ② replace the thermostat.
6 out of the water is not hot it is due to: 1. hot and cold water is not properly adjusted 2. power is not connected; 3. electric heater damage; 4. thermostat damage. Solution: 1. Properly adjust the opening of the hot and cold water mixing valve; 2. Adjust the power plug or switch to make good contact; 3. Replacement of the electric heater; 4. Repair or replacement of the thermostat.
Two, Chongqing Baiji water heater repair and installation methods
1. First of all, the owners should determine the installation location, and then mark it with a pen, and then use an impact drill to make holes and place expansion bolts to fix the water heater.
2. The inlet and outlet pipes out, screwed and fixed, and then put water to fill the container;
3. Accurately connected to the power supply fire wire, zero wire and ground, you can use the 16A plug, socket connection;
4. The water and electricity links to test, to see seepage out of the no, to see there is a leakage of electricity no, if they are all normal, then you can electrify the trial.
5 first square plastic molding fixed to the wall, the height of the family space according to their own convenience to adjust, when fixed, and then use the original production screws equipped with fixed, and finally use a drill to play two holes fixed on it.
The above content is today's decoration editorial about Chongqing Baiji water heater repair some common faults, as well as Chongqing Baiji water heater repair how to correctly install, I hope that you will help in the process of using the water heater in the future.