Universal lifting table milling machine what are the operating procedures?

1, before operation, check the universal lifting table milling machine parts of the handle is normal, according to the provisions of the lubricating oil, and low-speed test run 1 ~ 2 minutes, before operation.

2, before work should wear good working clothes, female workers should wear a working cap, operation is strictly prohibited wearing gloves.

3, clamping workpiece should be stable. Loading and unloading, tool setting, measuring, shifting, tightening the mandrel and cleaning the machine tool must be carried out after the universal lifting table milling machine is stopped.

4, the workbench is prohibited to place measuring tools, workpieces and other debris.

5, driving, should check the workpiece and milling cutter mutual position is appropriate.

6, universal lifting table milling machine automatically go knife, handle and screw should be disengaged; table can not go to two limit position, limit block should be placed firmly.

7, the worktable and elevating table before moving, you must loosen the set screws; not moving, tighten the nut.

8, the cutter bar, drawbar, collet and tool should be installed and tightened before power on, shall not be used to help loading and unloading of the spindle dynamic rotation.

9, the use of the end should be turned off the power supply, clean the machine, and will be placed in the empty position of the handle, the table moved to the center.