In the formal ground before the installation of ultrasonic cleaning machine, to be glued to the ultrasonic transducer (with a good pair of), glue, etc. should be prepared one by one first. At the same time, ultrasonic cleaning machine manufacturers should be glued to the ultrasonic transducer, cylinder stop sandblasting disposal, sandblasting adhesive surface must meet the requirements as well as the use of sandblasting certain requirements of the adamantine sand, sand requirements are relatively high, such as carefully selected, keep dry, etc.; and sandblasting when the pressure of the air tightening should be noted that the adjustment of the specified requirements, and through the gas source disposer dehumidification of the high-pressure air.
Two, attention should be paid to the relevant cleaning work
Ultrasonic cleaning equipment manufacturers, to spray a good sand cylinder and ultrasonic transducer first stop down to do a good job of cleaning, the latter to use a prepared solution to stop cleaning, the most basic to remove the appearance of some of the dirt, and then take the acetone for the next cleaning work. At the same time pay attention to the ultrasonic cleaning machine cylinder needs to be successively more than one cleaning process, cool dry and then take a specialized solution to stop a rinse, the thickness of the mesh pad should be in line with the requirements, and stainless steel mesh similarly clean and spare.
Third, pay attention to good drying, preheating
Should be cleaned ultrasonic transducer and cylinder and mesh pads into the oven to stop drying, drying temperature should also be controlled in the appropriate range, and then dry for 2 hours and cooled to a certain temperature to stop gluing. Ultrasonic cleaning machine company introduced in all the bonding preparatory tasks done, pay attention to match the glue (room temperature) fully harmonized to stop bonding quickly.