1. Disconnect the power supply: Before removing the syringe pump tie rod, make sure that the power supply to the device has been disconnected to ensure safe operation.
2. Loosen the locking screws: Locate the locking screws on the syringe pump (usually located near the tie rods) and use a suitable screwdriver or wrench to loosen them so that the tie rods can be easily moved.
3. Remove the tie rod: After the locking screw is loosened, carefully remove the syringe pump tie rod from the device. Be careful not to use excessive force as this may damage device components.
4. Inspect the tie rods: After removing the tie rods, inspect them for any damage or wear. If necessary, replace the tie rods with new ones.
5. Install new tie rods: Install the new syringe pump tie rods onto the unit, taking care to align the locking screw holes, and then re-tighten the locking screws to ensure that the tie rods are securely in place.
6. Reconnect power and test: After completing the above steps, reconnect power to the unit and test to ensure the syringe pump is working properly.
Please note that if you are unfamiliar with servicing and disassembling electronic devices, it is recommended that you seek professional assistance. During disassembly, it is important to follow the device manufacturer's recommendations and guidelines to ensure safety and proper operation of the device.