2, according to run a shutdown immediately show "Err02": line cross-section is relatively too thick, the speed is too fast, adjust the speed to slow down and try again; voltage is insufficient, need to add an independent voltage regulator; cutter head sensor dust or cutter head sensing locating iron variations, need to be cleaned up or repositioning of the iron.
3, running soundless "Err02": fuse broken, replace and try again, if broken again, need to replace one of the driver board.
4, the display appears "Err03": data input error, press the function key to browse once, change the wrong data. (Possibly wire head, wire tail length is greater than the length of the line)
5, the machine according to the operation of the cutter head for a movement, the wire is not transported, the display shows "Err04": the quantitative data is zero, need to enter the quantitative data; yield data has been the highest value, need to clear the yield zero. Press Yield, and then press Delete.
6, wire skin stripped out of a slant: adjust the catheter seat so that the center of the catheter and the center of the blade for the same straight line; catheter is too far away from the mouth of the knife, adjust the closer; whether the catheter is too large, need to change the appropriate catheter.
7, line tail skin stripped out of the slope: whether the catheter relay jumping normal. If you can not jump, you need to replace the relay or check whether the relay is poor contact (emergency solution: you can move the conduit position in the direction of the feed wheel, so that the distance from the mouth of the conduit to the blade is greater than the length of the wire tail)
8, the wire can not be peeled out: check the depth of cutting the wire, you need to regulate the diameter of the line to become larger; into the wheel pressure is not enough, you need to adjust the clearance and pressure into the wire wheel, the gap decreases or the pressure increases.
9, wire tail can not be peeled open: check the cutting depth of the tail, need to adjust the wire diameter larger; out of the wheel pressure is not enough, need to adjust the clearance and pressure out of the wheel, gap reduction or pressure increase.
10, wire embossing is too heavy: first of all, please judge the embossing from the wire wheel or wire wheel, the corresponding pressure knob to reduce or gap knob to increase. (If necessary, need to change the silicone wheel)
11, wire stripped when the core copper wire cut off a few: the diameter of the data will be reduced one by one, until the core copper wire does not hurt.
12, the total length does not match the actual appearance of the real line > set line length: into the wire wheel compression is not enough, and sometimes the phenomenon of wire stripping, wire stripping the line will be greater than the set line length, adjust the upper and lower wheels into the line gap, and reduce the gap or check the rolling wheel with teeth with dirt, need to be cleaned up; may have been entered with a decimal point of data, need to be cleared; the need to adjust the pulse equivalent. Check whether the motor synchronous belt has missing teeth or too loose.
13, the total length of the actual discrepancy between the real line < set line length: the wire itself is not the same thickness; rolling wheel with teeth have dirt, need to be cleaned up; wire surface wax, resulting in wax on the roller slippery, can be used to clean the toothbrush dipped in some gasoline or banana water. Need to adjust the pulse equivalent; check whether the motor synchronous belt has missing teeth or too loose.
14, wire head and tail cut off or no cut marks: If you check the wire head or tail belongs to the cut off, the length of the wire and the actual length of the wire head and tail of the short length of the wire diameter is too large, please adjust the wire diameter to become smaller. If you check the wire head or tail is not cut, the length of the wire is longer than the actual length of the wire head, the wire diameter is too small, please enter the wire diameter data to make it bigger.
15, sometimes the head or tail of the line is cut off: the knife mouth has a line of skin and dirt, need to be cleaned up; knife frame motor belt is too loose.