Today's dust pipeline cleaning dust in the way of compressed air cleaning, vacuum cleaning, acoustic cleaning and common manual cleaning. We on the main artificial dust and pipeline acoustic cleaning of these two to talk about. First of all, manual cleaning, in fact, if the dust collector for manual cleaning, is the need to regularly arrange for personnel from the cleaning hole to start cleaning, in addition to the side of the dust pipe on the top of the design should be considered, and cleaning hole can not have air leakage phenomenon. Air leakage detection is the acceptance of the dust collector to consider the link, if the air leakage, which will have an impact on the dust removal effect of the dust collector, but also cause the dust collector pipeline flow rate is reduced, which will lead to dust accumulation will be more. It should also be mentioned that about the larger diameter of the dust pipe, need to set up a few more cleaning holes, this should be customers and engineers to discuss, whether it is at the end of the elbow and other settings, but also to add some rubber sheet liner. In short, you have a qualified dust removal environmental protection enterprises, engineers will give you thorough consideration.
Then we will talk about the pipe acoustic cleaning. This is now a more advanced method of clearing the ash, is installed in the inlet flue a sonic blocking flow aid equipment, in addition to the dust removal system work, this equipment will produce vibration force, can let the dust and dust pipe wall stripping, so as to reduce the amount of dust accumulation. Not only reduces the labor cost, and the installation of this accessory pollution-free, clean and environmentally friendly.
Dust collector operation after a period of time, to regularly check the use of dust accessories, there is damage, to be replaced in a timely manner, so as not to affect the normal operation of the dust removal equipment.