Transfer handle failure, check the transfer handle line there is no poor contact, you can push the car to the after-sales point of detection and repair. Yadi electric car turn handle failure, such a fault can only be achieved by replacing the turn handle to achieve the function of the repair.
This may be caused by poor line contact, you can drive the car to the repair store, so that the maintenance master to the line to you to weld it, it should be the line of the turnbuckle loose, you can also look at their own, the turnbuckle line of the plug, whether it is loose, the line is off, if it is a new car that just bought, or to let the seller of the car store to deal with the better.
Electric bike riding attention points
1, the bicycle fastening screws and nuts should be screwed tight, shall not be loose and fall off.
2, the rotating parts should be flexible, there shall be no stuck, stiff phenomenon. For example: the front and rear wheels should rotate flexibly, and should not swing left and right and jump up and down, will stop when the wheel should be able to do before and after the light swing, can not suddenly stop rotating. Handlebar left and right rotation should be flexible, stirrup shaft and crank should be fastened, not loose each other, and flexible rotation.
3. The gearshift should be correct within the gearshift range, and the position of the gearshift should be clear, with no neutral gears in the middle.
4, the chain should be appropriate tension, flexible operation. If the crank sprocket is repeatedly shaken by hand in the forward and reverse directions, the chain should be flexible and there should be no chain jumping or falling off.
5. Hold the front and rear part of the saddle with both hands, and press the front end of the saddle with one hand, the front end of the saddle shall not be collapsed. Then use both hands to turn the saddle horizontally, the saddle should not turn.
6, brake and brake system selection: hold the handlebars with both hands, respectively, left and right brakes while pushing and pulling the bike back and forth, at this time the wheels should not rotate; release the handle, the brake system should be able to quickly reset.
7, the surface of each component should be clean, no stains, rust, trademark decals should be complete, clear, no sharp edges and burrs, such as mudguards and the edge of the chain cover should not have the feeling of zapping, brakes and other steel rope ends should be equipped with a protective sleeve.