1, manufacturers stamping quality control, spring thimble connector manufacturing process generally begins with stamping. Through a large high-speed stamping machine, spring thimble connectors are stamped from thin metal strips. One end of the large roll of metal tape is fed into the front of the press, the other end of the hydraulic table through the press is wrapped into the roll wheel, the roll wheel pulls out the metal tape and rolled and stamped out the finished product. In this process some finished products will appear quality problems, such as scratches, curled edges and so on, such a finished product shenzhen connector manufacturer chengyuxin is resolutely not allowed to pass.
2, spring thimble connector manufacturers electroplating control, spring thimble connector pins stamping is completed immediately after sending to electroplating. At this stage, with the stamping stage similar to a class of problems, such as pin twisting, cracking or deformation, but also in the process of stamping good pins into the plating equipment. In addition to this, uneven and abnormal plating colors can occur during the plating process. Appeal the problem of spring thimble will connector manufacturers are eliminated.
3, spring thimble manufacturers for injection molding quality control,? Spring thimble connector plastic box seat made in the injection molding stage. The usual process is to inject molten plastic into the metal tire film, and then quickly cooled to shape. The so-called "leakage holes" that occur when the molten plastic does not completely fill the tire membrane are a typical defect to be detected during the injection molding stage. Other defects include filled or partially blocked sockets (which must be kept clean and free of obstructions in order to be properly connected to the pins during final assembly). Machine vision systems for quality inspection after injection molding is complete are relatively simple to implement, as missing cassette holders and clogged jacks can be easily identified using backlighting.
4, spring thimble manufacturers for the assembly of quality control, spring thimble connector manufacturing is the final stage of the finished product assembly. Plating good pins and injection molding box seat plug in two ways: a separate plug or a combination of plug. Individual pairs of insertion refers to each time the insertion of a pin, a combination of pairs of insertion will be more than one pin at the same time with the box seat insertion. Regardless of the type of connection, the manufacturer requires that all pins are tested at the assembly stage to ensure that they are not missing and are positioned correctly, and another regular inspection task is related to the measurement of the pitch on the mating surface of the connector.