Red, green, blue? are the color base wires? Solder them on ?1?2?3? respectively.
Red, green and blue? s ground wires are soldered to ?6?7?8? respectively
Yellow and black? is the ? synchronization wires,? soldered to ?13, 14
VGA outer shield wire ? are soldered to 15 or the housing
This is the most basic 3+2 soldering, ? Display device can basically light up, if there is a problem with the color after welding, it must be 123 of the line welding connected, it is recommended to use heat shrink tubing isolation. If after welding? screen does not light, then it must be 13?14 have problems,
Note? Male? Female? s wire sequence is reversed!
In daily life, because of the renovation of the dark line, the VGA line of one end of the cut section, after the line is welded. Then you need to use a multimeter to measure the wire sequence of the two ends before welding, because each manufacturer has a different color standard for the wire!
If both ends are welded, then according to the above I said at the beginning of the can be