Methods 1: rabbit ears were ligated.
1, put on shoes without shoelaces.
2. Pull the left and right shoelaces at the same time to tighten the shoes.
3. "Cross your shoelaces left and right". The left shoelace is located above the right shoelace, and then passes through the right shoelace from top to bottom, pulling the left shoelace to form a new shoelace knot.
4. Hold the end of the new left shoelace and make a circle along it.
5. Wrap the new right shoelace in a circle, and then wrap the right shoelace on the left circle.
6. "Knoting" is the beginning of finishing tying shoelaces.
7. Tie this knot and it's over!
8. If you want to tie a double knot, just repeat the first two steps. It's your choice. Of course it's stronger, but it's not easy to untie.
Method 2: Standard knotting method
1, follow the steps given in the above method, not the following method, until a new left shoelace is looped.
2. Wrap the left and right shoelaces into a ring (make sure that the left index finger of the left hand presses the left shoelace ring, and wrap the right rope around the left shoelace ring).
3. Hold the right branch ring tightly and insert it into the small hole formed by the left branch ring and the right branch ring pressed by the index finger.
4. Pull out the right circle with the left index finger.
5. Tighten both sides.
6. If you want to tie a double knot, tie the newly made shoe ring up and down. This makes it a double knot.
7. If you want to tie three knots, tie a knot with two circles.
Method 3: Method 3
1. Pull the shoelaces of the left hand and the right hand, and pull them up to ensure a straight line.
Now put the shoelaces on both sides through the other side, so that the shoelaces in your hand form an X-shape.
3. Pull a shoelace, thread it into another shoelace, and then pull it. One shoelace is under the other. It should have been tied. T
4. Then, pull out a shoelace, wrap it around, and hold the bottom of the loop to make it close to the top of the shoe.
5. Take out another shoelace with the other hand and wrap it around the left circle.
6. Next, pass the same shoelaces mentioned in step 5 through the holes below the circle.
7. Finally, grab the new ring and the old ring and pull it slowly until it is tightened.
8. This is not only a shoelace but also a bow!
Tips to tie your child's shoelaces, be sure to tie the two shoelaces first, then cross them, and wear one shoelace under the other. Tighten them, then form a rabbit ear posture in the same way as above, and finally, tie the two ears together.
Please remember to wear left shoes for your left foot and right shoes for your right foot. This is not insulting you. Just to remind you to prevent a child from accidentally hurting his (her) feet when wearing shoes.
If you hurt your feet while walking outside, stop immediately, go to the nearest bench or sit on the surrounding ground immediately, and take off your shoes and socks, because it is possible that your shoes are too small to blister. Before you buy shoes, make sure they fit.
Only by learning how to tie your shoelaces can you tie them without thinking.
If the shoelace loops are too big, you may roll them into your shoes and trip yourself and others.
Pull two lace loops, and the shoes will look cooler.
Warning not to leave the index finger of your left hand in the small hole where the two shoelace loops intersect, otherwise it will be difficult to take your hand out of the tied shoelace.
The shoelaces will blister if they are tied too tightly.