Locate with the prepared horizontal line and the dividing line of the main bone of the rear keel. You can make the height lower than the boom. According to the keel dividing line, and set the hook distance of the keel boom. First, buckle the side without screws on the arranged steel bars and put them away. The screws that have not been put in place can be fixed with some expansion bolts first.
Installation method of keel in suspended ceiling technology
First, select the nut of the boom. Install the hanger on the trunk bone, and then hang the set trunk bone of the hanger at the position of the dividing line and pass through the corresponding hanger bolt. Fixing screw. Hang a hanger at the joint of the main bone. Connect and adjust the height. Its connection and parallel line are connected to the keel hole to add the keel and observe the structure of the corresponding point. At the same time, the firmware of the link card is also set, and then the fixed edge can be locked and the position can be stabilized with nails, but the distance between the two should be separated while stabilizing the position ~
Installation of secondary skeleton in suspended ceiling technology
According to the set accessory bone parting line, accessory bone hanger with one-to-one corresponding room number and accessory bone installation, a certain distance should be made one by one according to the designed scheme, accessory bone hanger should be hung on the main bone, when accessory bone needs more links to extend. You can choose the link connector of the secondary skeleton, and connect them together when installing the secondary skeleton ~
Ceiling installation in suspended ceiling technology
When installing the ceiling, all kinds of linked solid pipe fittings in the ceiling must be accepted to see if there are any minor problems. Small problems must be followed up in time, and the ceiling can only be installed after passing certain suppression tests. When installing the ceiling, adjust the straightness between the dragon turtle and the frame, and pay attention to opening different interfaces of the ceiling during installation. When installing the ceiling, you should not use excessive force, which has avoided the cracks at the interface caused by excessive force. You should also pay more attention to safety during the installation and operation of the ceiling to avoid cracking and damage of the ceiling and avoid these things as much as possible!