Drone operation is as follows:
1. Open the drone remote control and push the slide switch upward. It should be noted here that the slide switch of each drone is different, and the position is also different, you can refer to the manual.
2, using the function switch, all function keys are pushed to the front, and the throttle on the right side of the remote control is pushed to the bottom. Then we find the function switch on the reset remote control, push all the function keys in the circle to the front, and push the throttle on the right side of the remote control to the bottom.
3, connected to the power interface, the left stick back to the center, left and right direction to control the aircraft corresponding to the left and right movement.
Takeoff and landing practice
First of all, let's take a look at the takeoff process. Stay away from the drone, unlock the flight control, slowly push the throttle and wait for the drone to take off, this is the operation steps of takeoff. The throttle must be pushed slowly, even if it has been pushed a little distance and the motor has not started yet. This will prevent you from being unable to control the drone due to too much throttle.
When landing, you also need to pay attention to the order of operation: lower the throttle, so that the aircraft slowly close to the ground; about 5-250px from the ground slightly push the throttle to reduce the speed of descent; and then lower the throttle again until the drone touches the ground (after touching the bottom, do not push the throttle); throttle down to the lowest, lock the flight control. Compared to takeoff, landing is a more complicated process that requires repeated practice.