Remolding refers to the use of the original prototype, silicone molds made in a vacuum state, and in a vacuum state using PU, transparent PU, POM, ABS materials for casting, so as to clone the same as the original prototype copy. Can also be configured according to the customer's desired color together with a copy of the mold, the technology due to the speed, cost, greatly reducing the product development costs, cycle and risk. Using a silicone mold can make more than 20 pieces of the same product.
1, a plastic bowl with 500g of glue, at room temperature with hardener 1.5%, mix well and standby. 2, the mother of the mold blank lubricated with release agent treatment. 3, lubricated mother of the billet surrounded by wooden strips, wooden strips should also be treated with a release agent, the gap in the middle of the 2-4cm is appropriate. 4, will be equipped with a good glue along a fixed pouring point slowly, and vibrate from time to time to exclude the inside of the mold, and the mold is not a good choice. And from time to time vibration to exclude the air inside. 5, 60 minutes after the curing of the glue is completely surrounded by a wooden bar, leaving a gap of 4cm, folded away from the original wooden bar. 6, will be 1000g of gypsum powder to water and then injected into the wooden frame, injected until the full (the wooden frame should be divided into two parts of the plastic sheet in order to facilitate the removal of the mold). 7, 20 minutes after the removal of the wooden bar, the mold that is done.