How to choose the right air compressor?

How to choose the right air compressor:\x0d\ Preparing to buy an air compressor, the first thing to do is to determine the working pressure needed at the air-using end, plus a margin of 1-2 bar, and then choose the pressure of the air compressor, (the margin is to consider the pressure loss from the compressor's installation site to the actual distance of the piping distance to the air-using end, according to the length of the distance between the appropriate consideration of the pressure margin between 1-2 bar). Of course, the size of the piping diameter and the number of turning points are also factors affecting the pressure loss. The larger the piping diameter and the fewer the turning points, the smaller the pressure loss; conversely, the larger the pressure loss. \x0d\ Therefore, when the distance between the air compressor and the pipelines of each air end is too far, the diameter of the main pipeline should be enlarged appropriately. If the environmental conditions meet the installation requirements of the air compressor and the working conditions permit, it can be installed close to the air-using end. \x0d\\ Volume flow rate selection \x0d\ 1, in the selection of air compressor volume flow rate, you should first understand the volume flow rate of all the air-using equipment, multiply the total number of flow rate by 1.2 (i.e., amplify the margin of 20%); \x0d\ 2, the new project can be based on the new project on the flow rate provided by the design institute to select the flow rate value; \x0d\ 3, from the air-using equipment suppliers to understand the volume flow rate of the equipment to select the parameters of the air-using equipment \x0d\ 4, air compressor station renovation can refer to the original parameter values combined with the actual use of gas selection; \x0d\ appropriate selection, the user itself and air compressor equipment are beneficial, selection of too large a waste, selection of too small may cause the air compressor in a long time in the loading state or the use of gas is not enough or the pressure does not play on the shortcomings of the other.