Linear guide belongs to the precision parts, and therefore require considerable caution in the use of the attitude, even if the use of high-performance linear guide, if not used properly, can not achieve the expected performance results, and easy to make the linear guide damage. Therefore, the use of linear guide should pay attention to the following matters:
Prevent corrosion
Directly with the hands of the linear guide, to fully wash off the hands of sweat, and coated with high-quality mineral oil and then operate, in the rainy season and the summer months, especially pay attention to anti-rust.
Keep the environment clean
Keep the linear guide and its surroundings clean even if the tiny dust invisible to the naked eye into the guide, will increase the wear and tear of the guide, vibration and noise.
Installation should be careful
Linear guide in the use of installation should be careful, do not allow strong stamping, not allowed to use the hammer to directly hit the guide, not allowed to pass the pressure through the rolling body.
Installation tools to be appropriate
Linear guide to use appropriate, accurate installation tools try to use special tools, and strongly avoid the use of cloth and short fibers and the like.
Cleaning and maintenance note:
In order to ensure that the machine has a high degree of processing accuracy, the requirements of its guide rails, linear has a high degree of guiding accuracy and good smoothness of movement. Equipment in the operation process, due to the processed parts in the processing will produce a large amount of corrosive dust and smoke, based on these smoke and dust long-term large deposits in the guide rail, linear axis surface, the processing accuracy of the equipment has a great impact, and will be in the guide rail linear axis surface formation of etching points, shorten the service life of the equipment. In order to make the machine work normally and stably, to ensure the processing quality of the product, we should seriously do a good job of the guide rail, linear axis of the daily maintenance. Our forrun mall engineers often use the method is: clean guide please prepare - dry cotton cloth, lubricating oil. First of all, move the laser head to the most right (or left), find the linear guide, wipe with a dry cotton cloth until shiny and dust-free, plus a little lubricant (sewing machine oil can be used, do not use machine oil), the laser head left and right to slowly push a few times, so that the lubricant can be evenly distributed. Roller guide cleaning: move the beam to the inner side, open the end cover on both sides of the machine, find the guide rail, use dry cotton cloth to wipe the two sides of the guide rail and roller contact place clean, then move the beam, clean the remaining place.