cleaning machine for the laboratory
, will certainly first understand the laboratory
Ultrasonic cleaning
machine which is good, which quality and cost-effective, but in the long term use of the quality of even better cleaning machine will inevitably appear some
anomalies
, so the Operators should know more or less some simple, common troubleshooting methods. Let me introduce
laboratory ultrasonic cleaner
common failures and processing
1, no ultrasonic
Once the laboratory ultrasonic cleaner without ultrasonic this anomaly, the first thing to do is to check the power supply voltage, if the
rated
compatible with the value of the rated value
or fluctuations in large, then you need to replace it immediately. Then it needs to be replaced immediately. Secondly, we should check the power socket, switch and
terminal
, wire, if there is a loose on the re-connect firmly. Finally, you should also check the insurance and transistor, if there is an abnormal spark sound or damage, you need to immediately replace the new insurance and transistor.
2, ultrasonic wave is weak or occur
Whistling
Start the laboratory ultrasonic cleaner, if the ultrasonic wave is found to be very weak or the phenomenon of whistling, then first of all check
cable line
,
transducer
and
insulation resistance
value, to ensure that these are not damp and damaged. After making sure that these are not damp and damaged, the power supply voltage should be checked, and if it is too low, appropriate measures should be taken to ensure that the voltage meets the requirements. Finally, check the temperature of the
cleaning fluid
to ensure that the temperature is in line with the use of the equipment range.
3, leakage
Once the laboratory ultrasonic cleaner found leakage, then first of all to pull out the high-frequency plug, distinguish clearly is the body or generator failure, so first look at the power line, if there is no moisture, damaged, and then take a look at the stability of the power supply voltage, often fluctuate sharply, then, but also make it affected, it must be dealt with in a timely manner. If there is no problem with the power line, we have to look at the equipment, if the moisture
corroded
will have to be repaired in a timely manner.
These aspects of the above for you to introduce, is the laboratory ultrasonic cleaning process often occurs in some abnormal faults and the corresponding measures. We must fully understand, so that
If the future
encountered these abnormalities, you will be able to take the first time to correctly respond to the measures, of course, the procurement of good after-sales service laboratory ultrasonic cleaner is also very important. If you encounter problems that you can not deal with, then
after-sales service system
perfect manufacturers will certainly lend a helping hand in a timely manner.