1, first to ensure that the beam from the laser tube into the center of the # 1 mirror.
2, in front of the 2 # reflector with double-sided tape, move the beam to the closest position of the laser tube, according to the spot (to control the appropriate intensity of light), hit a mark (special attention: to prevent laser radiation injuries, please use a piece of cardboard to test out the approximate location of the spot, and then adjusted).
3. Gradually move the beam to the furthest position from the laser tube, press spot and put a mark.
4, if the two marks do not overlap, adjust the 1 # reflector, so that the center of these two marks overlap.
5. Repeat the second to fourth steps until the two markers are perfectly centered.
6, in front of the 3 # reflector with double-sided tape, the cart (laser head) to the closest position of the 2 # reflector, according to the point shot (to control the appropriate intensity of light), hit a mark.
7, gradually move the laser head (cart) to the farthest position from the 2 # reflector, according to the point shot (it is best to use a piece of cardboard, first measured the approximate location of the spot, to prevent injuries), hit a mark.
8, if the two marks do not coincide, adjust the 2 # reflector, so that the center of the two marks coincide.
9, repeat the sixth step to the eighth step, until the center of the two marks completely coincide.
10, in front of the 3 # reflector into the light hole on the double-sided tape, point shooting, marking. If in the center, it is qualified.
11, if the laser does not fall in the center of the light-intake hole, in the figure falls off the top and outside.
Up and down deviation: can only raise or lower the laser tube.
Inward and outward deviation: the laser tube can only be adjusted inward or outward.
In the diagram, the laser tube must be lowered and then, re-adjusted all the way from the first step.
Second, verticality adjustment
1, the optical path of the four points of adjustment overlap, and the laser will be adjusted to the middle of the 3 # reflector
2, CM and TM series of machines by adjusting the 3 # reflector on the 3 copper screws so that the laser from the middle of the jet through
3, YM series of models by the 3 # reflector under the pad double-sided adhesive tape so that the laser from the middle of the jet through!
4, if there is a slight deviation from the left and right, adjust the 3 # head seat to the left or right so that the optical path is vertical
5, if there is a slight deviation from the front and back, generally due to the 3 # head seat itself has a deviation caused by the replacement of the re-adjustment of the optical path can be adjusted vertically.