The types and styles of the plate but there are a lot of, perhaps in this regard many people do not know a lot, so that in the choice of time there will be a lot of doubt, for medical clean plate is what material, is not all feel very doubtful? Then take a look at the following introduction, and the ceiling may also choose to use the clean plate, so it is also necessary to understand the construction process of the clean plate ceiling.
What is the material of the medical clean plate
For the material of the medical clean plate, in fact, is the MDF cement board as the basic material, and then use UV paint as raw material in the UV light curing process, a kind of decoration on the plate.
UV paint coating attached to the surface of the plate, through the irradiation of ultraviolet light, instantaneous curing into a film, and high curing content, hardness, plate surface smooth, with good antibacterial ability. UV clean color plate, mainly used for medical clean room, operating room, ICU wards and channel corridor wall decoration.
Construction process of clean board ceiling
1, the installation of the keel boom
With the level of flat line and the keel has been done after the location of the main bone score line. Then you can make the height of the underside of the boom. According to make the keel line and set the hook distance of the keel boom. The screwless side of the hook is fastened to the steel bar that has already been laid out. The screws that have not yet been placed can be fixed with some expansion bolts.
2, the keel installation
First choose the nuts of the boom. In the main bone installation of good hanging, and then set up a good hanging piece of the main bone, according to the position of the line of good use of the hanging piece hanging into, put him across in the corresponding boom bolt. Get the screws. Hang the pendant at the joint of the main bone. Connect the wires and adjust the height. Its connection and flat line connected to the keel hole to add keel, observe the structure of the corresponding point. At the same time also set up a good link card firmware, then you can lock the fixed side, with nails to stabilize the position, but in the stable position at the same time, but also to separate out their distance.
3, the installation of secondary bone
According to set up a good secondary bone line, one by one room number secondary bone of the pendant, the installation of secondary bone in accordance with the design of the program one by one to make a certain distance, the secondary bone pendant hanging in the main bone above, when the secondary bone needs a few more links to connect the length. You can choose the secondary bone link connector, in the installation of the secondary bone together.
4, the installation of the ceiling
In the installation of the ceiling, the ceiling must be linked to a variety of solid pipe fittings for acceptance, to see if there are some minor problems, if encountered minor problems must be followed up in a timely manner, and to be qualified by a certain pressure test before the installation of the ceiling. In the installation of the ceiling at the same time to adjust the dragon turtle and border straight, at the same time in the process of installation should be noted that different open link ceiling interface.
The above has introduced you to the medical clean plate is what material and clean plate ceiling construction process? After reading it is not already understood? In fact, the construction of the ceiling must ask the specialized staff, so that the steps will be more reasonable, the installation out of the effect is also impeccable. After that, it is about the selection of the plate, be sure to go to the regular stores to choose, quality is not to worry.